Jet Tools JPS-10TS instruction

This .pdf document is bookmarked

Operating Instructions and Parts Manual

10-inch ProShop™ Table Saw with Riving Knife

Model JPS-10TS

(shown with steel wings and 30” rail set)
for serial no. 11120136 and higher
WALTER MEIER (Manufacturing) Inc.
427 New Sanford Road
LaVergne, Tennessee 37086	Part No. M-708490
Ph.: 800-274-6848	Revision B1 04/2012
www.waltermeier.com	Copyright © 2012 Walter Meier (Manufacturing) Inc.

Image 1

Jet Tools JPS-10TS operating instructions Inch ProShop Table Saw with Riving Knife

Contents

Inch ProShop Table Saw with Riving Knife More Information Warranty and service Table of contents Safety warnings Kickback Prevention KickbackProtection Tips from Kickback About this manual Glossary 708495K Features Specifications Arbor and blade Shipping contents Setup and assembly Installing legs Unpacking and cleanupHandwheels Switch bracket Extension wing adjustmentExtension wings Rails and fence Riving knife Use care when working around an installed bladeAnti-kickback pawls Blade guard Blade installation/replacement Low profile riving knife Aligning blade guard and riving knifeTable insert Miter gauge Grounding instructions Electrical connectionsVoltage conversion Adjustments Page Table to blade alignment OperationsKickbacks Rip sawing Page Crosscutting Resawing Do not use the standard table insert for dadoing operations Bevel and miter operations Feather board Safety devicesFiller piece Push stick & push block Cleaning MaintenanceWeekly Lubrication Optional accessories Replacement Parts Troubleshooting the JPS-10TSSymptom Possible Cause Correction Motor and Trunnion Exploded View Index No Description Size Qty Motor and Trunnion Parts List JPS10TSR -174MF JPS10TSR-HP Table and Cabinet Exploded View JPS10TSR-TIA Table and Cabinet Parts List JPS10TSR-AKPA Stand Assembly Exploded View Stand Assembly Parts List Cast Iron Wings Exploded View Cast Iron Wings Parts List Electrical Connections Electrical Connections Page Walter Meier Manufacturing Inc