8.5Extension wings

Referring to Figure 7:

Make sure mating surfaces are clean and free of burrs.

1.Attach right extension wing (J) to saw table using four screws and washers (HP-4/8). Hand-tighten only at this time.

2.Repeat for left side.

Figure 7

8.6Extension wing adjustment

Referring to Figure 8:

Level extension wing (J) to saw table using a straight edge (L). A metal straight edge is ideal, although a carefully jointed board may also be used, as shown.

Figure 8

1.Begin with the extension wings raised slightly higher than the main table. Tighten the four screws (13mm wrench) under the extension wing that secure it to the saw table. Tighten these just enough to hold the wing in place but loose enough to change the wing height by tapping on it.

2.Lay straight edge across saw table and extension wing, extending out past edge of wing, as shown.

3.Move straight edge to several places along the wing, as you continue to nudge the

extension wing level with saw table. When extension wing is level with table, securely tighten each of the four screws.

4.Repeat steps 1 through 3 for opposite extension wing.

5.Reinstall right side motor cover.

8.7Rails and fence

To install front and rear rails and fence, consult manual M-708482 which accompanies your fence assembly, then proceed to section 8.9.

8.8Wood extension table

To install the optional wood table, consult manual M-708482, which accompanies your fence assembly, then proceed to section 8.9.

8.9Switch bracket

Referring to Figure 9:

Use two screws and washers (HP-5/8) to secure switch bracket (M) to front rail.

Figure 9

8.10Dust Hood

Referring to Figure 10:

Install dust hood at rear of cabinet, using four small lock knobs (HP-3). The dust port should be toward the bottom.

A dust collection system, with minimum capacity of 350 cubic feet per minute, should be connected to the port via a 4-inch diameter hose (not included). Note: Dryer vent hose is not acceptable for this purpose.

An extensive line of JET dust collectors is available – contact your dealer or visit our website for information.

12

Page 12
Image 12
Jet Tools JPS-10TS Extension wings, Extension wing adjustment, Rails and fence, Wood extension table, Switch bracket