Fast Heat-up function
After a cooking function has been selected and the temperature has been adjusted, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on selected function and temperature. If it is necessary to reach the required temperature in a shorter time, the Fast
1)Switch the oven on by pressing button .
2)Set the required cooking function and temperature as explained in the previous pages.
3)Set the temperature by pressing button “ ” or “”. The temperature will appear on the display.
4)Press Fast
5)press Oven functions button and the symbol “°” will flash for approximately 10 seconds. Now it is possible to select
the required temperature by pressing button “ “ or
“ “.
4)When the required temperature is reached, an acoustic alarm will sound for a short time, and the temperature display will revert to the set temperature.
This function can be used with any cooking function or temperature.
Demo mode
This mode is intended to be used in the shops to demon- strate the oven functionality without any power consump- tion except the oven lamp. To activate this function the appliance should be in
—Press Fast
—Press button and the “id” indication will appear in the display.
All oven functions can be selected.
The thermometer symbol will not flash anymore and “id” indication will be replaced by number digits.
Follow the above described procedure to disable
the demo mode.
Error code
The electronic programmer does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and it will show on the display the corresponding error code (letter F followed by digits).
For further details, refer to chapter "Something not work- ing“ on page 27.
Fig. 17
Fig. 18
14