John Lewis JLBIOS603 Installation, Electrical Connection, Technical Data, Electrical Requirements

Installation

Technical Data

Dimensions of recess		Heating elements rating
Height	580 mm	Conventional Oven (Top element+Bottom element) 1,800 W
Width	560 mm	Top element	800	W
Depth	550 mm	Bottom element	1,000	W
		Fan Oven	2,000	W
Dimensions of the oven cavity		Inner Grill element	1,650	W
Height	335 mm	Full Grill element	2,450	W
Width	395 mm	Pizza Oven	2,000 W/1,000 W
Depth	400 mm	Pyrolytic cleaning function	2,450	W
Oven capacity	53 litres	Thermal Grilling	1,675	W
		Convection Fan	25 W
		Oven Light	40 W
		Cooling Fan	25 W
		Total Rating	2,500	W
		Supply voltage (50 Hz)	230 V

Electrical Connection

THIS OVEN MUST BE EARTHED

Electrical Requirements

Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety this should be undertaken by a qualified electrician, e.g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC).

Electrical Connection

The oven is designed to be connected to 230 V (50 Hz) electricity supply.

Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate on the side of the oven door.

The oven has an easily accessible terminal block which is marked as follows:

Letter L		-	Live terminal
Letter N		-	Neutral terminal
	or E	-	Earth terminal

The cable used to connect the oven to the electrical supply must comply to the specifications given below.

It is necessary that you install a double pole switch between the oven and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current rules.

The switch must not break the yellow and green earth cable at any point.

It is necessary that the yellow/green earth wire is about 2 cm longer than the live and neutral ones.

Important

After installation and connecting, the cable must be placed so that it cannot at any point reach a temperature of more than 60°C above the ambient temperature.

Before the oven is connected, check that the main fuse and the domestic installation can support the load; and that the power supply is properly earthed.

The manufacturer disclaims any responsibility should these safety measures not be carried out.

For UK use only

Connection	Min. size	Cable / flex	Fuse
via	Cable/flex	type
• Cooker	2.5 mm2	PVC/PVC	20 A
Control		twin and
Circuit		earth

For Europe use	only
Min. size Cable/flex	Cable / flex type	Fuse
2.5 mm2	H07 RN-F, H05 RN-F,	15 A
	H05 RR-F, H05 VV-F,
	H05 V2V2-F (T90),
	H05 BB-F

5