Gas Connection
NOTE: IF THE OPTIONAL BLOWER KIT (# 129161) IS TO BE INSTALLED ON THE STOVE AT THE TIME OF THE INSTALLATION OR IN THE FUTURE, THE GAS SUPPLY LINE SHOULD BE INSTALLED AS CLOSE TO THE FLOOR AS POSSIBLE. USE OF A 90° ELBOW DIRECTLY OFF THE VALVE TO ALLOW FOR ADEQUATE CLEARANCE FOR THE BLOWER. See Figure 15.
The gas supply line connection is made to the valve just inside the left rear leg. The Gas supply line should be 3/8" or 1/2" diameter, or the appropriate size to provide sufficient gas pressure to the valve regardless of the input setting.
The use of Flexible Gas Appliance Connectors is acceptable in many areas in the U.S., however, Canadian methods vary depending on local code.
ALL INSTALLATIONS MUST COMPLY WITH LOCAL CODE OR IN THE ABSENCE OF LOCAL CODE, MUST COMPLY WITH THE MOST RECENT EDITION OF THE NATIONAL FUEL GAS CODE ANSI Z223.1/NFPA 54 OR
All codes require: a gas shutoff valve (gas cock) and union, to be installed in the supply line, and in the same room as the appliance. This allows for the disconnection of the stove for servicing and mainte- nance. See Figure 15.
A
Secure all joints tightly using appropriate tools and sealing compounds (for propane units be sure to use compounds that are propane resistant). Turn on gas supply and test for gas leaks using a soapy water solution. Never use an open flame to check for leaks.
Leak test:
1.Mix a
2.Light appliance- see lighting instructions on page 22 of this manual or on the stove’s rating plate.
3.Brush or spray all joints and connections with the soapy water solution.
4.If bubbles appear at any connection or seam or a gas odor is detected immediately turn gas control knob to the OFF position.
5.Tighten or reconnect the leaking joint and retest for any gas leaks.
Gas Pressure
Correct gas pressure is essential for efficient and safe operation of the Allagash gas stove. It is impor- tant that the correct pressure is established at the time of the installation. Proper gas pressure provides a consistent flow of gas to the appliance and is instrumental in checking for gas leaks. The gas control valve on the stove is equipped with pressure test points for gauge connections. The gauge connec- tions are located on the front of the valve under the On/Off/Pilot- knob. See Fig. 16. Gauge connections are identified by:
•E for inlet or supply pressure ( the amount of gas coming to the valve.)
•A for manifold pressure (the amount of gas that is coming out of the valve to the burner.)
Control Valve
Figure 15. Gas supply valve types and fittings.
EA
Figure 16. Inlet and Manifold pressure test points.
INLET GAS PRESSURES (inches water column)
| MIN | MAX |
NATURAL GAS | 5.0 WC | 7.0 WC |
PROPANE | 11.0WC | 13.5WC |
14
