Power Fuse | Juniper Networks 200 Series specs

The Rear Panel

Power Fuse

Each NetScreen-200 Series device uses a 2.5 Amp, slow-blow power fuse rated for 250 Volts.

To replace a fuse on a NetScreen-200 Series device:

1.Take the device off-line by turning the power switch OFF and disconnecting the power cable.

2.Using a screwdriver, separate the lid of the external fuse cover from the surface of the power outlet.

3.Gently remove the fuse assembly.

4.Slide the new fuse into the opening until the fuse clicks into place.

5.Replace the power cable, then turn the device power switch ON.

NetScreen-200 Series

7

Image 13

Juniper Networks 200 Series manual Power Fuse

Contents

NETSCREEN-200 Series Copyright Notice Contents IX-I Guide Organization Preface Juniper Networks Netscreen Publications Command Line Interface CLI Conventions Overview1 NetScreen-208 Device NetScreen-204 DeviceNETSCREEN-200 Systems Front Panel System Status LED Display Alarm Asset Recovery Pinhole Compact Flash Card Slot Console and Modem Ports Ethernet Interfaces Power SuppliesRear Panel Power Fuse Overview User’s Guide Installing the Device General Installation Guidelines Equipment Rack Installation GuidelinesPerforming EQUIPMENT-RACK Installation Front Mount Connecting the PowerMid-Mount Wiring a DC Power Supply Connecting the NETSCREEN-200 Device to Other Devices Installing the Device User’s Guide Configuring the Device Route Mode Transparent ModeOperational Modes Ethernet1 through ethernet8 NETSCREEN-200 Series Device Interfaces Connectivity Examples Connecting the Device AS a Single Security Gateway Performing Device Connection Device Establishing AN HA Connection Between Devices Device Establishing a Terminal Emulator Connection Performing Initial Connection and Configuration Setting Port and Interface IP Addresses Changing Your Admin Name and Password Setting the IP Address of the Management Interface Configuring the Device for Telnet and Webui Sessions Starting a Console Session Using Telnet Establishing a GUI Management Session Starting a Console Session Using Dialup NetScreen WebUI application window appears Asset Recovery Using CLI Commands to Reset the Device Using the Asset Recovery Pinhole to Reset the Device Configuring the Device User’s Guide Specifications Safety Certifications Electrical SpecificationNETSCREEN-200 Attributes Environmental Index IX-II