Connections

Do not connect the power cord until all other connections have been made.

Connecting a USB mass storage class device

You can connect a USB mass storage class device such as a USB flash memory device, hard disk drive, multimedia card reader, digital camera, etc. to this system.

•After connecting a USB mass storage class device to this system and selecting USB MEMORY as the source, the file control display appears on the TV screen. (See page 24.)

Center unit (on the front panel)

USB cable (not supplied)

NOTE

•Connect one USB mass storage class device to the system at a time. Do not use a USB hub.

•While playing back a file in a USB mass storage class device, do not disconnect the device. It may cause a malfunction of both the system and the device.

•JVC bears no responsibility for any loss of data in the USB mass storage class device while using this system.

•When connecting with a USB cable, use a cable less than 1 m (3.3 ft) in length.

•This system is compatible with USB 2.0 Full Speed.

•You can play back the following types of files in a USB mass storage class device (maximum data transfer rate: 2 Mbps):

–Music: MP3, WMA, WAV

–Picture : JPEG

–Movie : MPEG-1, MPEG-2, ASF

•To view a picture/movie files in a USB mass storage class device on the TV, connect the system to the TV via the composite, S-video or component jacks. (See page 9.)

•You cannot play back a file larger than 2 GB.

•When playing a file which has a large transfer rate, frames or sounds may be dropped during playback.

•This system cannot recognize a USB mass storage class device whose rating exceeds 5 V/500 mA.

•This system may not recognize some USB mass storage class devices and does not support DRM (Digital Rights Management).

•This system may not play back some files even though their formats are listed above.

•The battery of a USB mass storage class device is charged while “USB MEMORY” is selected as the source.

•You cannot connect a computer to the (USB MEMORY) terminal of the system.

•When connecting a USB mass storage device, refer also to its manual.

•An iPod does not play on the USB MEMORY terminal.

Connecting the iPod

Center unit (on the front panel)

Turn the arrow-mark side left when connecting the plug.

Connection cable for iPod

 

(supplied)

Stand for iPod (supplied)

CAUTION

•Be sure to reduce the volume on the system to the minimum level before connecting an iPod. Adjust the volume after playback has started.

•DO NOT connect or disconnect the iPod when the system is turned on.

NOTE

•To disconnect the connection cable from the iPod, hold the buttons on the sides of the plug then pull it out.

•You cannot send any data to your iPod from the system.

•Do not carry the System with iPod connected. You might drop it or it might cause damages to the connector part.

•Do not touch or hit the iPod terminal pins or connector pins directly. It might cause damages to the connector part.

•“iPod” indicator lights up during iPod connectivity.

•To view a video/picture from the iPod on the TV, connect the system to the TV via the composite or S-video jacks. (See page 9.)

•iPod does not correspond to the component video output.

Connecting the power cord

Center unit

Plug into an AC outlet.

Power cord

CAUTION

•Disconnect the power cord before cleaning or moving the system.

•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp and pull the plug so as not to damage the cord.

NOTE

•If the wall outlet does not match the AC plug, use an AC plug adapter (not supplied).

13