JVC CA-FSB70 manual Connecting Speakers, English, 2Hold the clamp of the speaker terminal

English

AM antenna

1

ANTENNA

Vinyl-covered wire

(not supplied)

2

AM loop antenna

(supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals or connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

To connect speakers

You can connect the speakers using the speaker cords.

1
2		3,4
SPEAKERS
RIGHT	LEFT
Speaker	SPEAKER	Speaker
cord		cord
	IMPEDANCE
	6~16Ω
Right speaker		Left speaker

1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

2Hold the clamp of the speaker terminal.

3Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: ª to ª and

·to ·.

4Release your finger from the clamp.

IMPORTANT:

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to one speaker terminal.

7