3 Press 2 or 3 to select the video signal type suitable for the TV.

•When the TV is connected to the [VIDEO] terminal or the [S-VIDEO] terminal, the video signal type can be selected as instructed below.

-Select “NTSC 480I” for a TV only compati- ble with NTSC interlaced video siginal.

-Select “NTSC 480P” for a TV equipped with a component terminal and compatible with NTSC progressive video signal.

-Select “PAL 576I” for a TV only compatible with PAL interlaced video signal.

-Select “PAL 576P” for a TV equipped with a component terminal and compatible with PAL progressive video signal.

•When the TV is connected to the [HDMI] ter- minal, the video signal type can be selected as instructed below. (Only for DD-8 and DD-3)

-Select “AUTO” for normal usage (the initial setting).*

-Select “NTSC 480P”, “NTSC 720P”, “PAL 576P” or “PAL 720P” as needed.

NOTE

*The “AUTO” setting works only for a TV compat- ible with PAL video signal. Select “NTSC 480P”

or “NTSC 720P” for a TV equipped with an HDMI terminal and compatible with NTSC video signal.

•“480”, “576” and “720” refer to the number of the scanning lines. Generally, the larger the number, the better picture that can be obtained.

•“I” refers to the interlaced format. “P” refers to the progressive format. A better picture can be obtained in the progressive format than in the interlaced format.

•When an HDMI video signal is output, the “HDMI” indicator lights up in the display window.

•When an HD video signal (720p) is output, the “HD” indicator lights up.

•When “NTSC 480P”, “NTSC 720P”, “PAL 576P” or “PAL 720P” is selected, the “PROGRESSIVE” indicator lights up in the display window.

4 Press [ENTER].

•The selected video signal type is displayed in the display window for a short time.

NOTE

•The picture may be distorted when you press [ENTER], but this is not a malfunction of the sys- tem.

•To check the compatibility of your TV, contact your local JVC customer service center.

•All JVC-manufactured progressive TVs and high-definition TVs are fully compatible with this system.

•Even if the main unit is turned off, the video sig- nal type setting is stored.

Selecting the monitor out type

To view an image on the TV, select the monitor out type as well as the video signal type.

1 Press [SETTING].2 Press 5 or / to display “M.OUT”.3 Press 2 or 3 to select “HDMI” or “NO HDMI”.

•When using an HDMI cable to connect a TV to the main unit, select “HDMI”.

•When an HDMI cable is not connected, select “NO HDMI” (the initial setting).

4 Press [ENTER] or wait for a short time.

Preparation

14