Basic Operations

■Projector’s buttons

STAND BY indicator

OPERATE indicator

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TEMP

 

 

STAND BY

OPERATE LAMP

 

EMERGENCY AV

RGB

OPERATE button 2, 1

MAIN POWER switch 1, 2

■Remote control unit

QUICK

 

OPERATE button 2, 1

ALIGN.

OPERATE

 

AV HIDE

PRESET

PAGE BACK

 

LENS LOCK

N

 

 

M

 

 

E

 

 

N

 

 

U/

 

UNLOCK

E

 

T

 

 

E

 

 

R

 

AV RGB/COMPUTER

U T +

SHIFT ZOOM FOCUS

D W –

LENS

■Caution on extended projection:

When projection continues for an extended amount of time, be sure to allow the lamp to be turned off for at least two minutes for every 72 hours of continued projection.

If you do otherwise, the service life of the lamp may be severely affected.

The following describes the basic procedure for normal use of the projector.

1.Turning on the Power1Turn on the MAIN POWER switch of the projector.

ON [ ❙ ]: The main power turns on and the STAND BY indicator comes on.

Projector’s indicator

STAND BY

2Press the OPERATE button for one second or more.(Or press the remote control’s OPERATE button for one second or more.)

•The OPERATE indicator comes on.

•About 30 seconds after the MAIN POWER switch is turned on, you can start projecting.

Remote control unit

Projector

OPERATE

or

OPERATE

Note

•After the power is turned on, the screen may be jumbled for a few seconds, but this is not a malfunction.

■Turning off the Power1Press the OPERATE button for one second or more.

(Or press the remote control’s OPERATE button for one second or more.)

•The STAND BY indicator changes to blinking, and the projector goes into cool-down mode.

Example of the

projector’s buttonProjector

\

OPERATE

STAND BY

 

2Turn off the MAIN POWER switch after the cooling fans have stopped running.

OFF [‡]: The MAIN POWER switch turns off and the STAND BY indicator goes off.

Projector

STAND BY

*Do not turn off the MAIN POWER switch during cool down mode (the STAND BY indicator blinking). About 10 minutes after the STAND BY indicator comes on steady (stand-by mode), the cooling fans (except the one for the light-source lamp power supply) will stop, and then turn off the MAIN POWER switch.

24