Operating the Main Menu

Setting Up Channels (SW No setup)

■Remote control unit

QUICK

 

 

ALIGN.

OPERATE

 

 

AV HIDE

 

PRESET

PAGE BACK

PAGE BACK button

LENS LOCK

 

N

 

 

M

 

 

E

 

 

N

 

 

U

 

 

/

 

UNLOCK

E

 

T

 

 

 

 

E

 

 

R

MENU/ENTER button

 

 

This setup procedure is to make dedicate switcher operation linked to the selection of designated channels.

When a switcher number “SW No” is selected:

The “Switcher number setup menu” is displayed.

•To be able to display a menu, a “SOURCE” needs to be already set.

S W I T C H E R

S W I T C H E R NO. 1

AV RGB/COMPUTER

U T +

SHIFT ZOOM FOCUS

D W –

LENS

(SWITCHER No. setting menu)

■CHANNEL setup • selection menu

C H A N N E L

 

 

( A U T O )

 

CH

L I N E

S O U R C E

SWNo

1

Y / C

N T S C ( 4 8 0 i )

1

2

V I D E O

P A L / S E C A M

2

3

4

5

6

7

8

9 10

Note

•The selected item is shown in magenta color. Items shown in gray color cannot be operated or set in the current mode. (If no line is registered, you cannot set any “SW No” item.)

1 Press MENU/ENTER toward the 2 or 3 mark to select a switcher number.

•Numbers that you can select from are numbers from 1 to 20 and characters “■■” that signify non-registration.

•If you press MENU/ENTER toward the 2 mark, the number becomes smaller, and pressing the button toward the 3 mark makes the number larger.

•If you select “■■”, “SW No” will be deselected.

•If the selected channel is the same with the one in ( ) under the “CHANNEL” display at the top of the “CHANNEL setup • selection menu”, the registration or settings cannot be cleared.

2 Press the PAGE BACK button to set.

•When you press PAGE BACK, the switcher number is set, and the display returns to the “CHANNEL setup/ selection menu”.

•Be careful that if you set the same switcher number to a few channels and operate using the switcher number, the youngest-number channel is switched to because channels are read in the order of channel numbers.

Note

•You can automatically switch the channels of the projector by specifying a switcher number through an external controller.

As an example, if switcher number 1 (SW No1) has been registered to channel number 1 (CH1), specifying switcher number 1 (SW No1) automatically switches the projector to channel number 1 (CH1). (For this operation, a setup is required to communicate between the projector and the external controller.)

For information on external controllers, contact the dealer where you purchased your projector.

50