JVC DR-M70SEK manual Timer recording, Enter the date using Cursor U / D, then press Cursor P

Recording

Timer recording

Video	VR
DVD-RW	DVD-RW DVD-R

You can set the unit to record up to 8 programmes, up to a month in advance. Daily or weekly programme recordings are also available.

•Be sure to set the clock before entering a timer programming.

•You can select the timer programming list by pressing [PROG] twice. In this case, continue from step 5.

Insert a recordable disc.

1 In stop mode, press [SET UP].

2 If you select “Advanced Setting Menu,” proceed to step 3.

If you select “Easy Setting Menu,” proceed to step 4.

3 Select “Recording” using

[Cursor U / D], then press [ENTER].

4 Select “Timer Programming” using [Cursor U / D], then press [ENTER].

The Timer Programming list will appear.

5 Select a programme that is not set using [Cursor U / D], then press [ENTER].

Timer Programming

Date Start End CH Speed

1.- - -

2.- - -

3.- - -

4.- - -

5.- - -

6.- - -

7.- - -

8.- - -

6 Enter the date using [Cursor U / D], then press [Cursor P].

Each time you press [Cursor D] at the current date, the timer recording mode will change as follows.

e.g., 1st January

01/01

Daily

M-F (Mon.-Fri.)

W-SAT

W-FRI

W-SUN

31/01

7 Enter the time to start and to end using [Cursor U / D], then press [Cursor P].

8 Select the channel number to record using [Cursor U / D], then press [Cursor P].

To record from external input, select “AV1,” “AV2,” “AV3” or “AV4”.

9 Select the recording speed using [Cursor U / D], then press [Cursor P]. (See page 20.)

10 Press [ENTER] when all information required is entered.

Your programme setting is stored.

•To set another programme, repeat steps 5 to 10.

•To exit, press [SET UP] or [PROG].

•If the recording times of two or more programmes overlap, “Overlap” and overlapped programme numbers are displayed. (See pages 27 and 29.)

Timer Programming

Date	Start	End	CH	Speed
1. 01/01	12:00	13:00	P01	XP

2.- - -

3.- - -

4.- - -

5.- - -

6.- - -

7.- - -

8.- - -

11 Press [STANDBY/ON y/I].

The icon will appear on the front panel display and the unit enters to the timer-standby mode.

Note

•If you have not set the clock, the clock setting window will appear after step 4. Continue from step 5 in “Clock Setting” on page 19 before programming the timer.

•Press [Cursor L / P] to move the cursor in the timer programming menu.

26 EN