JVC DR-M70SEK manual To select a channel, To skip a Preset channel, Move

Select “Skip” using [Cursor U / D], then press [ENTER].

Follow steps 1 to 3 in “Manual tuning.”

Select “Position” using

[Cursor U / D], then press [ENTER].

Getting Started

•If “Skip” is set to “ON,” select “Skip” using [Cursor U / D], then press [ENTER]. Select “OFF” using [Cursor U / D], then press [RETURN].

•If you want to decode scrambled signals, select “Decoder” using [Cursor U / D], then press [ENTER]. Select “ON” using [Cursor U / D], then press [RETURN].

•To store another channel, repeat steps 4 to 7.

8 After completion, press [SET UP] to exit.

To select a channel

Notes on using the Number buttons:

•Enter channel numbers as a two-digit number for the quickest result. For example, to select channel 6, press [0] and [6]. If you only press [6], channel 6 will be selected after 2 seconds. You can only select channels 1 to 99.

•You can select the external input mode “AV1”, “AV2”, “AV3” or “AV4.”

•To select “AV1,” press [0], [0], [1].

•To select “AV2,” press [0], [0], [2].

•To select “AV3,” press [0], [0], [3].

•To select “AV4,” press [0], [0], [4].

To skip a Preset channel

You can set the unit to skip channels you can no longer receive or seldom watch when you access channels using [PR +/-].

1

2

3 Select the position number you wish to skip using [the Number buttons] or [Cursor U / D], then press [RETURN].

4

5 Select “ON” using [Cursor U / D], then press [RETURN].

• To skip another channel, repeat steps 2 to 5.

6 Press [SET UP] to exit.

Move

You can replace two channels.

1 In stop mode, press [SET UP].

2 Select “Advanced Setting Menu” using [Cursor U / D], then press [ENTER].

If it has already appeared, proceed to step 3.

3 Select “Channel” using

[Cursor U / D], then press [ENTER].

4 Select “Move” using [Cursor U / D], then press [ENTER].

5 Select the position number of which you want to change the channel using [Cursor U / D], then press [ENTER].

You cannot select a position number where “– – –” appears next to the number, because “Skip” is set to “ON” for that position number.

6 Move the channel to another position number using

[Cursor U / D], then press [ENTER].

• To move another channel, repeat steps 5 to 6.

7 Press [SET UP] to exit.

18 EN