JVC DR-M70SEK manual Installing batteries in the remote control, About the remote control

20RETURN button

•Press to return to the previously displayed menu screen.

21B (SKIP) button

•During playback, press to skip to the previous chapter or track.

•When playback is paused, press to play reverse step by step.

F(SKIP) button

•During playback, press to skip to the next chapter or track.

•When playback is paused, press to advance step by step.

22PLAY P button*

•Press to start or resume playback.

23SLOW /REV r button

•During playback, press to reverse fast.

•When playback is paused, press to reverse slowly.

SLOW /FWD f button

•During playback, press to forward fast.

•When playback is paused, press to forward slowly.

24PAUSE p button

•Press to pause playback or recording.

25STOP S button*

•Press to stop playing back or recording.

Button names described in the Instruction Manual

The instructions in this manual are described mainly with the operations using the remote control. Some operations can be carried out using the buttons on the front panel.

Installing batteries in the remote control

Install two R6 (AA) batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1 2 3

Caution

•Incorrect use of batteries can result in hazards such as leakage and bursting.

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together.

•Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

•Remove batteries if the equipment will not be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

About the remote control

•Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

•Use within the operating range and angle as shown.

Within about 7 m

60˚

Remote control

•Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

•Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

•Replace the batteries when the operating range of the remote control reduces.

Before you start

EN 11