JVC DR-M70SEK manual Settings for external equipment, Connection to external equipment

(See page 20.)

Settings for external equipment

Connection to external equipment

Video VR

DVD-RW DVD-RW DVD-R

Connect the external equipment using either the input jacks, AV1, AV2, AV3 (Rear) or AV4 (Front). However, for AV4 jacks, you have to select S-VIDEO input or VIDEO input jacks depending on the connected devices.

Use commercially available Scart, S-Video or Video cable and an Audio cable for this connection.

	1	In stop mode, press [SET UP].
	2	Select “Advanced Setting Menu”
		using [Cursor U / D], then press
Recording
		[ENTER].
	3	If it has already appeared, proceed to step 3.
		Select “Select Video” using
	4	[Cursor U / D], then press [ENTER].
		Press [ENTER].
	5	Select the input jack type to be used
		using [Cursor U / D], then press
		[ENTER].
			AV4 (Front)
			Video In
			S-Video In

•If you want to use VIDEO input jack (Composite), select “Video In”.

•If you want to use S-VIDEO input jack, select “S-Video In”.

6 Press [SET UP] to exit.

Recording from external equipment

Video VR

DVD-RW DVD-RW DVD-R

Before recording from external equipment, see page 15 for connection instructions.

1 Turn the TV and the unit on, and select the input of the TV to which the unit is connected.

2 Press [OPEN/CLOSE O] to open the disc tray, then place the disc to record on.

3 Press [OPEN/CLOSE O] to close the disc tray.

4 Select the input terminal to which the external equipment is connected. (AV1, AV2, AV3 or AV4)

To use the input jacks on the back of the unit, select the “AV1,” “AV2,” or “AV3” position by pressing [0], [0], [1] or [0], [0], [2] or [0], [0], [3] on the remote control or using [PR +/-].

To use the input jacks on the front of this unit, select “AV4” position by pressing [0], [0], [4] on the remote control or using [PR +/-].

5 Select a recording speed using [REC SPEED].

6 Press [REC I] on the unit to start recording.

7 Press the PLAY button on the external recording component.

8 Press [STOP S] on the unit to stop recording.

Note

•During recording, if a signal other than PAL is detected (such as NTSC), recording is paused.

30 EN