JVC DT-V2000SU manual Input a

CONTROLS AND FEATURES (cont’d.)

11 REMOTE IN/OUT terminal

External control input and output terminal. Instead of using the INPUT SELECT button, an external control signal changes the INPUT mode. INPUT mode status data is also output through this terminal.

* The terminal is DIN 8-pin (female).

[REMOTE IN/OUT terminal specifications]

7	8	6	Pin No.	Signal
			1	REMOTE ENABLE
3		1	2	SELECT 1
5	2	4	3	SELECT 2
			4	STATUS 1
			5	STATUS 2
			6	NC
			7	GND
			8	GND

To test external control, short-circuit the REMOTE ENABLE terminal (Pin No. 1) to the GND terminal (Pin No. 8) so that the external remote control becomes valid (L level). Then, turn the SELECT 1 terminal (Pin No. 2) and the SELECT 2 terminal (Pin No. 3) ON to select the INPUT SELECT mode.

[Connection Image]

DT-V2000SU
(REMOTE IN/OUT terminal)			External controller
REMOTE ENABLE 1		TTL level
		TTL level
SELECT 1	2
SELECT 2	3	TTL level
GND	8		GND
STATUS 1	4		TTL level
			STATUS 1
STATUS 2	5		TTL level
			STATUS 2

Pin No.

Notes:

●To test external control, short-circuit the REMOTE ENABLE terminal (Pin No. 1) to the GND terminal (Pin No. 8) so that the external remote control becomes valid (L level). External control doesn’t function when external remote control is invalid (H level).

●The POWER SAVE function doesn’t work when external remote control is valid.

12 EXT SYNC terminals (available only for

INPUT A)

Input (IN) and output (OUT) terminals for horizontal synchronization (HD) or composite synchronization (Cs) signals, as well as vertical synchronization (VD) signals. The output terminal is bridge-connected.

*Available only for INPUT A.

*Synchronization signals are automatically detected. External synchronization is selected when HD/VD or Cs is input. The priority is as follows: HD/VD > Cs.

13 AUDIO INPUT terminal

Audio input terminal (RCA pin-jack).

*The audio input level is 500 mVrms. Sound becomes distorted when a signal greater than 1 Vrms is input.

14 AC inlet [AC INPUT]

Power input connector. Connect the provided AC power cord %.

15 Power cord

Provided power cord for connecting the AC inlet [AC INPUT] $ to an AC outlet (120 V AC, 60 Hz).

External Control Input in the Input Mode

(INPUT SELECT)

Input mode	SELECT 2	SELECT 1
(INPUT SELECT)
INPUT A	L	L
INPUT B	L	H
INPUT C	H	L

Output of Input Mode Status in the Input Mode (INPUT SELECT)

STATUS 2	STATUS 1	Input Mode
		(INPUT SELECT)
		Status Data
		Output
L	L	INPUT A
L	H	INPUT B
H	L	INPUT C

6