Connecting the WS antenna

For safety reasons, make sure that the unit is not plugged in and batteries are not installed when making connections.

To remove the WS antenna from the housing platform

Pull up on the front end of the antenna unit to unlock the base. The WS antenna should then be easily removable.

To install the WS antenna

1.To install the WS antenna, orient the antenna by lining up the arrow marks on the front of the WS antenna and on the front side of the housing platform. Slide the antenna into the housing platform at an angle so that the groove on the back side of the base of the antenna fits into the corresponding tab on this unit.

\

2.Push down on the front end of the base of the antenna until it clicks into place.

To connect the antenna cable

Connect the antenna cable to the antenna jack located on the rear panel of the unit.

ANTENNA

WARNING

• DO NOT PUT BATTERY IN BACKWARDS, MIX WITH USED OR OTHER BATTERY TYPES-MAY EXPLODE OR LEAK AND CAUSE PERSONAL INJURY.

• REMOVE THE BATTERIES ("D" SIZE, R20) WHEN USING THE AC POWER.

• SEE INSTRUCTION MANUAL.

CAUTION:

DO NOT FORCE THE WS ANTENNA INTO OR OUT OF THE HOUSING PLATFORM. THIS MAY CAUSE DAMAGE TO THE WS ANTENNA AND CAUSE THIS UNIT TO PERFORM IMPROPERLY.

To connect the extension cable.

1.Disconnect the WS antenna from the antenna jack.

2.Connect the extension cable into the antenna jack on the rear panel of the unit.

3.Slide the rain protection cover on the extension cable back so that the connector protrudes.

4.Firmly connect the extension cable with the WS antenna cable.

5.Slide the rain protection cover over the connected section completely for best performance.

Notes:

Be sure not to place the back of this unit against a wall or other surface when the antenna cable is connected as it may damage the cable and/or antenna jack.

Be sure to check that the cable under and not over the handle of the unit. If the cable is over the handle, using the handle to carry this unit may be the cause of malfunction.

CAUTION:

The rain protection cover is not intended to be left out in heavy rain or submerged in water. Please avoid exposing this section of the cable to excessive moisture.

Notes:

To help ensure long-lasting performance of this unit, do not leave the extension cable and antenna outside or in direct sunlight for long periods of time. It is recommended that you restore the WS antenna to the housing platform when you are finished using the unit.

The WS specified extension cable supplied with this unit is specially designed for use with this unit. Should you use a cable not supplied with this unit nor recommended by JVC for use with this unit, JVC cannot guarantee the performance of this unit. For details regarding compatibility with this unit, please consult with the manufacturer of the cable.

To adjust the WS antenna

For details on how to position the WS antenna for best possible reception, refer to page 9.

5