To set the Self-Timer:
1.Make sure that the camera is in Record mode. Then, press the 
Mode/Menu button for over 2 seconds to enter the camera options in Record mode.
2.Keep on pressing the 
Mode/Menu button repeatedly until 
blinks on the LCD panel.
3.Press the Shutter button to select the option.
Setting the Auto Flash Mode
The camera has two different flash modes:
●Off (default) 
: The flash is disabled no matter what the ambient brightness of the surroundings is.
●Auto 
: The camera automatically fires the flash when the brightness of the subject or scene is too low.
To set the Auto Flash mode:
1.Make sure that the camera is in Record mode.
2.Use the 
/ - button to choose the Auto Flash mode (Auto 
). The camera starts charging the flash and the Status light indicator blinks. The Status light indicator stays lit when the flash is charged and ready.
Note
Do not fire the flash at a person at short range.
Auto Flash is always reset to “OFF ” when the camera is turned on.
Auto Flash will be disabled automatically when connected on USB because the large charge current will cause damage to your USB interface.
Do not use the
Setting the Exposure Value
This camera automatically chooses the most appropriate Exposure Value (EV) for a given situation. However, the EV system can also be manually compensated as follows:
1.Make sure the camera is in Record mode.
2.The LCD panel shows the EV Compensation scale. Press the EV / + button (located at the left side of the LCD panel on the back of the camera) to select a higher or lower value.
Note
The effective EV Compensation range of this camera is from
Becomes | Becomes |
darker | brighter |
