JVC GD-17L1G, GD-19L1G manual Installation, Unpacking the Monitor, Setup, Stand method of STAND

Installation

Please follow the instructions in this chapter to install your LCD Monitor.

Note:Before connecting your monitor, first read through the instructions in this chapter and the safety precautions in the previous chapter.

Unpacking the Monitor

When you are unpacking the monitor, make sure that you have the following items:

ÖThe LCD monitor

ÖAC power cord

ÖAnalog video signal cable

ÖRemote control

ÖBattery x 2

ÖBNC-RCA adaptor

ÖThis instruction book

Note:Place the monitor on a flat, sturdy surface. Choose an area free from excessive heat, moisture, and sunlight.

Setup

Note：

●Please do not lay your elbow and lean on this monitor.

●Please do not hold the liquid crystal part when you set it up.

●If the installation is imperfect, the monitor may fall down and cause the injury and the breakdown etc.

Stand method of STAND

●Please hold down the rear of the monitor firmly.

●Please pave the cloth etc. so as not to damage the liquid crystal panel.

●When tilting the monitor, make sure the following. -Tilt it slowly holding the stand firmly.

-Do not hold the liquid crystal part.

-Be careful not to get your fingers caught between the monitor and the stand.

6