Select the input signal

Power On/Off and input signal selection

INPUT

— +

INPUT — VOL +

Press the INPUT button to select the input signal to be played back from the equipment which has been connected to the Plasma Display.

Select the input signals to be connected by installing the optional Video Input Card.

(see page 30)

Input signals will change as follows:

INPUT

SURROUND

VOL

For Component Input

AV Component PC

For RGB Input

AV RGB PC

Note:

Input buttons do not work if no optional Video Input Card is installed.

Selecting the On-Screen Menu Language

INPUT

SET UP

Press to display the Set Up menu.

Press to select the OSD Language.

SURROUND

VOL

PICTURE

SOUND

SET UP

Press to select your preferred language.

Selectable languages

English(UK)

Deutsch

Français

Italiano

Español

ENGLISH(US)

.......(Chinese)

Setup
Component/RGB-in select	RGB
	RGB
Signal
Screensaver	English (UK)
OSD Language	English (UK)
Set up TIMER

Page 15

Image 15

JVC GD-V501PCE Select the input signal, Selecting the On-Screen Menu Language, Power On/Off and input signal selection

Contents

Plasma Display Monitor GD-V501PCEINSTRUCTIONS Table of Contents Trademark Credits Important Safety Notice For UK only Important the Moulded Plug Important Safety Notice Safety Precautions SetupWhen using the Plasma Display Cleaning and maintenance Safety PrecautionsIf problems occur during use Check that you have the accessories and items shown AccessoriesAccessories Supply Optional Accessories Helpful Hint Remote Control BatteriesPrecaution on battery use Observe the following precaution Cable fixing bands Connections PC Input Terminals connection Installing the ferrite core Small sizeInstalling the ferrite core Large size Signal Names for D-sub 15P Connector Communication parameters Installing the ferrite coreCommand Serial Terminals connection Basic Controls Basic Controls Input button AVS Video, Component/RGB and PC Mode SelectionSound mute On/Off see Volume Adjustment OFF Timer button AC cord connection Power On/Off and input signal selectionPower On/Off Connecting the plug to the Wall Outlet Select the input signal Power On/Off and input signal selectionSelecting the On-Screen Menu Language To Picture adjust menu Press to select each item See On-Screen Menu Display from Remote Control See page 30 Component see To Signal screen for PC see On-Screen Menu Display from Remote Control Aspect Controls Auto Aspect ControlsZoom Just Adjusting screen Adjusting Picture Pos./Size Pos Adjusting Picture Pos./SizeSize Clock Phase RGB/PC in Mode Helpful Hint N / Normalise Normalisation Treble Sound AdjustmentMute Bass Surround Controls On OffSurround Surround Button Cinema Picture AdjustmentsNormal Dynamic Picture Adjustments Advanced Settings Present Time Set Set up Timer Setup Timer Timer Set To stop the Screensaver under On, press the button Mode selectionScreensaver For preventing after-images Reversal / Scroll selection Setup of Screensaver Time Side Panel AdjustmentScreensaver For preventing after-images Setup for Input Signals Component/RGB-in Select3D Y/C Filter For Ntsc AV images If the picture image becomes unstable Setup for Input SignalsColour system / Aspect Auto Pulldown Freq. kHz/V-Freq. Hz Setup for input signals SyncSetting RGB sync signal Setting PC sync signal Plasma Display panel Symptoms Check Troubleshooting PC RGB input AV input signalsComponent /RGB/PC input signals Connection to the Optional Video Input Card. IF-C50P1G Video signal connection AV Input Terminals connectionVideo 4 pin socket AV Out Component signals Y, PB, PR connection RGB signal R, G, B, HD, VD connectionComponent/RGB Input connection Specifications Optional Supplied SpecificationsDimensions Mass Weight GD-V501PCE Plasma Display Monitor

JVC GD-V501PCE manual Select the input signal, Selecting the On-Screen Menu Language

Models: GD-V501PCE

Power On/Off and input signal selection