JVC GET0200-001A, GET0200-002A, GET0199-005A Assigning names to CDs, To erase the input characters

Assigning names to CDs

You can assign names to CDs (both in this unit and in the CD changer—only for KD-G801). After assigning a name, it will appears on the display when you select the source.

Source	Maximum number of characters
CDs*	Up to 32 characters (up to 40 discs)

*You cannot assign a name to a CD Text or an MP3/WMA disc.

1 Select a CD you want to assign a name to.

(For KD-G801) (For KD-G701)

When you select CD as the source, the

power automatically comes on.

2 While pressing DISP (display), press and hold SEL (select) for more than 2 seconds.

3 Select the character set you want while the first character position is flashing.

Each time you press the button, the character set changes as follows:

(A – Z: capital)	(a – z: small)
(Accented letters:
lower case)
	(0 – 9: numbers,
(Accented letters:
upper case)	and symbols)

4 Select a character.

• About the available

characters, see page 52.

5 Move the cursor to the next (or previous) character position.

6 Repeat steps 3 to 5 until you finish entering the name.

7 Finish the procedure while the last selected character is flashing.

To erase the input characters

To erase all the characters at a time, press and hold DISP (display) for more than 1 second as described in the procedure above.

Notes:

•When you try to assign a name to a 41st disc, “NAME FULL” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•Only for KD-G801: When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

ENGLISH

39