KD-R406/KD-R405

Installation/Connection Manual

°“√µ‘¥µ—Èß/§ŸË¡◊Õ°“√µ‘¥µ—Èß

GET0571-006A

[U/UH]

ENGLISH

This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.

0808DTSMDTJEIN

EN, TH

© 2008 Victor Company of Japan, Limited

‰∑¬

™ÿ¥ª√–°Õ∫π’ȉÈ√—∫°“√ÕÕ°·∫∫¡“‡æ◊ËÕ„™Èß“π°—∫√–∫∫¥°√–· ‰øøÈ“ “¬¥‘π¢—È«≈∫°√–· µ√ß12 ‚«≈∑Ï À“°√∂¬πµÏ¢Õߧÿ≥‰¡ò‰

¥È„™È√–∫∫π’È ÈÕß„™È‡§√◊ËÕß·ª≈ß°√µ–· ‰ø™Ë«¬´÷Ëß “¡“√∂À“´◊ÈՉȮ“°√È“π¥ ¢“¬‡§√◊ËÕ߇’¬ß√∂¬πµÏJVC

WARNINGS

To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

Be sure to ground this unit to the car’s chassis again after installation.

Notes:

Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.

It is recommended to connect speakers with a maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 22 of the INSTRUCTIONS).

To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape.

The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

Heat sink / ·ºËπ√–∫“¬§«“¡√ÈÕπ

§”‡µ◊Õπ

‡æ◊ËÕªÈÕß°—π°“√‡°‘¥‰øøÈ“≈—¥«ß®√¢Õ·π–π”„ÀȪ≈¥¢—È«·∫µ‡µÕ√’Ë≈∫ÕÕ°·≈È«®÷ßµËÕ “¬‰ø°ËÕ𵑥µ—È߇§√◊ËÕß

µ√«® Õ∫„ÀÈ·πË„®«Ë“‰¥È‡¥‘𠓬¥‘πµËÕ√–À«Ë“߇§√◊ËÕß°—∫µ—«∂—ß √∂¬πµÏ„À¡Ë·≈È«À≈—ß®“°µ‘¥µ—Èß

À¡“¬‡Àµÿ:

„™Èæ‘°—¥®”‡æ“–·∑πøî« À“°øî« Ï¢“¥∫ËÕ¬ „ÀȪ√÷°…“√È“ π¢“¬‡§√◊ËÕ߇’¬ß√∂¬πµÏJVC

¢Õ·π–π”„ÀȵËÕ≈”‚æß ∑’Ë¡’°”≈—ߢ—∫ ß ÿ¥‡°‘π°«Ë“50 W (∑—ÈßÈ“πÀπÈ“·≈–¥ ¥È“πÀ≈—ß ¡’§Ë“§«“¡µÈ“π∑“π4 ∂÷ß8 ) ∂È“°”≈—ߢ—∫µË”°«Ë“50 W „Àȇª≈’ˬπ§Ë““AMP GAIN” ‡æ◊ËÕªÈÕß°—π‰¡Ë„ÀÈ≈”‚æß™”√ÿ¥(¥ŸÀπÈ“22§”·π–π”)

°“√ªÈÕß°—π°“√≈—¥«ß®√ ®–µÈÕßæ—π¢—È« “¬µ–—°Ë«∑’ˉ¡Ë„™È·≈È«¥È«¬‡∑ ªæ—𠓬‰ø

·ºËπ√–∫“¬§«“¡√ÈÕπ®–ÈÕπ¡“°À≈√—ß®“°„™È √–¡—¥√–«—ßլ˓‰ª —¡º— ‡¡◊ËÕ∂Õ¥™ÿ¥ª√–°Õ∫π’È

PRECAUTIONS on power supply and speaker connections:

DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

¢ÈÕ§«√√–«—ß ”À√—∫°“√µËÕ·À≈߮˓¬°”≈—ß·≈–≈”‚æß:

լ˓µËÕ “¬µ–°—Ë«‡§‡∫‘≈°”≈—ߢÕß≈”‚æ߇¢È“°—∫·∫µ‡µÕ√’Ë√∂¬πµÏ ¡‘©–π—Èπ ÿ™¥ª√–°Õ∫®–‰¥È√—∫§«“¡‡ ’¬À“¬¡“°

°ËÕπ∑’Ë®–ËÕµ “¬µ–°—Ë«‡§‡∫‘≈°”≈—ߢÕß≈”‚æ߇¢È“°—∫≈”‚æß „Àȵ√«® Õ∫°“√‡¥‘𠓬‰ø≈”‚æß„π√∂¢Õߧÿ≥„Àȇ√’¬∫√ÈÕ¬‡ ’¬°ËÕπ

Parts list for installation and connection

√“¬°“√ Ë«πª√–°Õ∫ ”À√—∫µ‘¥µ—Èß·≈–‡™◊ËÕ¡µËÕ°—π

The following parts are provided for this unit. If any item is missing, consult your JVC car audio dealer

Ë«πª√–°Õ∫µËÕ‰ªπ’È„À¡“°—∫™ÿ¥ª√–°Õ∫π’È À“°¡’ ‘Ëß„¥‰¡Ë§√∫ °√ÿ≥“ª√÷°…“µ—«·∑π®”ÀπË“¬‡§√◊ËÕ߇’¬ßµ‘¥√∂¬πµÏJVC‚¥¬∑—π∑’

immediately.

 

A / B

C

D

E

Hard case/Control panel

Sleeve

Trim plate

Power cord

≈—ß∫√√®ÿ/ÀπÈ“ªí¥

ª≈Õ°ÀÿÈ¡

·ºËπ‚≈À–¢Õ∫·µËß

“¬‡§‡∫‘≈°”≈—ß

F

G

H

I

Washer (ø5)

Lock nut (M5)

Mounting bolt (M4 × 5 mm; M5 × 12.5 mm)

Rubber cushion

ª√–‡°Áπ«ß·À«π(ø5)

πÕµ≈ÁÕ§(M5)

≈—°µ‘¥(M4 × 5 ¡¡.; M5 × 12.5 ¡¡.)

¬“ß°—π°√–·∑°

J

K

L

Handles

Remote controller

Battery

§—π∫—ߧ—∫

√’‚¡µ§Õπ‚∑√≈

·∫µ‡µÕ√

1

Page 113
Image 113
JVC GET0570-001A manual KD-R406/KD-R405