JVC GR-AX827 Recording, Tally lamp Program AE, START/STOP INT. Time REC Time, RM-V700U RM-V705U

If the PROGRAM AE dial is set to “ automatically selected.

”, 15S is

RELEASE SELF-TIMER MODE

4 To release when the tally lamp is not blinking, press INT. TIME continuously until “ ” disappears. To release when the tally lamp is blinking, press Recording Start/Stop to stop the blinking, then press INT. TIME continuously until “ ” disappears.

NOTE:

3 Press Recording Start/Stop. The tally lamp begins blinking, and the blinking speed increases about

5 seconds before recording starts. When recording begins, the lamp stops blinking but stays lit.

SET TIME DELAY

Make sure the lens cover is open, set the power switch to CAMERA.

1

2 On the remote control, press INT. TIME to set the delay time. There are four choices, and they appear in the viewfinder in the following order (each time INT. TIME is pressed): 15S (15 seconds), 30S

(30 seconds), 1MIN (1 minute) and 5MIN

(5 minutes). Pressing again releases the Self-timer.

Self-Timer

You can set the delay between pressing Recording Start/ Stop and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.

NOTE:

You need the RM-V705U or RM-V700U remote control unit to perform this procedure.

ENGAGE RECORD–STANDBY MODE

Advanced Features

26RECORDING

Tally lamp PROGRAM AE

START/STOP

INT. TIME

REC TIME

RM-V700U	OR	RM-V705U	START DELAYED RECORDING
(optional)		(provided)