18 EN VIDEO RECORDING
|
| Basic Recording | ● When a blank portion is left between recorded | |
|
| |||
|
| scenes on the tape, the time code is interrupted | ||
|
|
| and errors may occur when editing the tape. To | |
NOTE: | ||||
avoid this, refer to “Recording From The Middle | ||||
Before continuing, perform the procedures listed | Of A Tape” ( pg. 20). | |||
below: | ● To record in LP (Long Play) mode, pg. 33. | |||
Tape Remaining Time | ||
Approximate tape | ||
● Open the LCD monitor fully. | ||
remaining time appears on | ||
● Select videos at 4:3 size or 16:9 (wide) size. | the display. “– – – min” | |
means the camcorder is | ||
calculating the remaining | ||
time. When the remaining time reaches | ||
| ||
| 2 minutes, the indication starts blinking. | |
Zoom Lever | ● The time required to calculate and display the | |
remaining tape length, and the accuracy of the | ||
| calculation, may vary according to the type of | |
| tape used. |
Lock Button
Recording Start/Stop
Button
1 Set the VIDEO/MEMORY Switch to “VIDEO”.
2 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.
3 Press START/STOP button to start recording. “REC” appears on the display while recording is in progress. To stop recording Press START/STOP again.
Approximate recording timeQuick Review
Enables to check the end of the last recording. 1) Press QUICK REVIEW during
the 
2) Tape is rewound for about 
several seconds and played back 
automatically, then pauses in the
●Distortion may occur at start of playback. This is normal.
●Slide the Power Zoom lever repeatedly to change the sound setting to on/off.
Tape | Recording mode | |
|
| |
| SP | LP |
|
|
|
30 min. | 30 min. | 45 min. |
|
|
|
60 min. | 60 min. | 90 min. |
|
|
|
80 min. | 80 min. | 120 min. |
|
|
|
NOTES:
●If the
5 minutes and no operation is performed, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and