EDITING EN 45

Audio Dubbing

The audio track can be customized only when recorded in the 12-BIT and SP modes.

( pg. 33)

●Use the provided remote control.

Speaker

START/

STOP

PAUSE

REW PLAY

INSERT STOP

A.DUB

Stereo

Microphone

1 Play back the tape to locate the point where editing will start, then press PAUSE (8).

2 While holding A. DUB () on the remote control, press PAUSE (8). The “8” indicator appears.

3 Press PLAY (3), then begin “narrating”. Speak into the microphone.

●To pause dubbing, press PAUSE (8).

4 To end Audio Dubbing, press PAUSE (8), then STOP (7).

To hear the dubbed sound during playback

Set “NARRATION” to “ON” or “MIX” ( pg. 35).

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at 12-BIT, the old and new soundtracks are recorded separately.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and out points. The original audio remains unchanged.

●Use the provided remote control.

NOTES:

●Before performing the following steps, make sure that “TIME CODE” for “DISPLAY” in both Recording and Playback Menus is set to “ON”. ( pg. 34, 35)

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

1 Play back the tape, locate the Edit-Out point and press PAUSE (8). Confirm the time code at this point. ( pg. 20)

2 Press REW (1) until the Edit-In point is located, then press PAUSE (8).

3 Press and hold INSERT ( ) on the remote control, then press PAUSE (8). The “8 ” indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 Press START/STOP to begin editing.

●Confirm the insert at the time code you checked in step 1.

●To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (7) on the remote control.

NOTES:

●Program AE, Effects and Shutter Effects

( pg. 41) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops.

ADVANCED FEATURES