TROUBLESHOOTING EN 47

➜If the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 8)

Aspect ratio is strange

If the aspect ratio of the video you are playing is strange, change the setting in “16:9 OUTPUT”. ( pg. 34, 35)

The remote control does not work.

●“REMOTE” is set to “OFF”.

➜Set “REMOTE” to “ON”. ( pg. 34)

●The remote control does not point at the remote sensor.

➜Point at the remote sensor. ( pg. 24)

●The remote control batteries are exhausted. ➜Replace the batteries with fresh ones.

( pg. 24)

Displays the battery remaining power.

Remaining power level

 

 

 

 

 

 

 

 

 

 

 

 

 

 

High

 

 

 

 

Exhausted

As the battery power comes close to nil, the battery remaining power indicator blinks.

When the battery power is exhausted, power turns off automatically.

TAPE END

Appears when the tape ends during recording or playback.

LENS CAP

Appears for 5 seconds after power is turned on if the lens cap is attached or when it is dark.

A. DUB ERROR!<CANNOT DUB ON A LP RECORDED TAPE><CANNOT DUB ON A 16BIT RECORDING> <CHECK TAPE’S ERASE PROTECTION TAB>

●Appears if Audio Dubbing is attempted on a blank portion of a tape. ( pg. 45)

●Appears if Audio Dubbing is attempted on a tape recorded in the LP mode. ( pg. 45)

●Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT audio. ( pg. 45)

●Appears if A. DUB ( ) on the remote control is pressed when the erase protection tab is set to “SAVE”. ( pg. 45)

INSERT ERROR!<CANNOT EDIT ON A LP RECORDED TAPE><CHECK TAPE’S ERASE PROTECTION TAB><CANNOT EDIT ON A BLANK PORTION>

●Appears if Insert Editing is attempted on a tape recorded in the LP mode. ( pg. 45)

●Appears if INSERT ( ) on the remote control is pressed when the erase protection tab is set to “SAVE”. ( pg. 45)

●Appears if Insert Editing is attempted on a blank portion of a tape. ( pg. 45)

MEMORY IS FULL

Appears when the memory card’s memory is full and shooting is not possible.

SET DATE/TIME!

●Appears when the date/time is not set. ( pg. 15).

●The built-in clock battery has run out and the

previously set date/time has been erased.

➜Consult your nearest JVC dealer for replacement.

UNIT IN SAFEGUARD MODEREMOVE AND REATTACH BATTERY OR DC PLUG

Error indications 01, 02 or 06.

Remedy: Remove and reattach the power supply or battery.

UNIT IN SAFEGUARD MODE

EJECT AND REINSERT TAPE

Error indications 03 or 04.

Remedy: Eject the cassette and reinsert.

In the above 2 error indications, the camcorder turns off automatically. Eject the cassette once and re-insert it, then check if the indication clears. When it does, you can resume using the camcorder. If the indication remains, consult your nearest JVC dealer.

REFERENCES