EN29
Menu Screen Explanations
FADER/WIPE
PROGRAM AE
W.BALANCE
REC MODE
SOUND |
| 12 BIT |
MODE |
|
|
|
|
|
|
| 16 BIT |
ZOOM |
| 10X |
|
|
|
|
| 40X |
CAMERA |
|
|
| 300X | |
|
| |
|
| |
SNAP MODE | ||
GAIN UP |
| OFF |
|
|
|
|
| AGC |
|
| AUTO |
CAMERA | VIDEO | |
MODE |
| |
DUAL | ||
| ||
| ||
DIS |
| |
OFF | ||
MANUAL |
| |
ON |
Refer to “Fade/Wipe Effects” ( pg. 34, 35).
Refer to “Program AE With Special Effects” ( pg. 36, 37).
Refer to “White Balance Adjustment” and “Manual White Balance Operation” ( pg. 39).
Allows you to set the video recording mode (SP or LP) depending on your
Enables video recording of stereo sound on four separate channels, and is recommended for use when performing audio dubbing. (Equivalent to the 32 kHz mode of previous models)
Enables video recording of stereo sound on two separate channels. (Equiva- lent to the 48 kHz mode of previous models)
When set to “10X” while using digital zoom, the zoom magnification will reset to 10X since digital zoom will be disengaged.
Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 10X (the optical zoom limit), to a maximum of 40X digital magnification.
Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 10X (the optical zoom limit), to a maximum of 300X digital magnification.
Refer to “Snapshot (For Video Recording)” ( pg. 20).
Allows you to shoot dark scenes with no picture brightness adjustment.
The overall appearance may be grainy, but the image is bright.
The shutter speed is automatically adjusted (1/30 — 1/200 sec.). Shooting a subject in low or poor lighting at 1/30 sec. shutter speed provides a brighter image than in the AGC mode, but the subject’s movements are not smooth or natural. The overall appearance may be grainy. While the shutter speed is
being automatically adjusted, “
” is displayed.
Enables regular video shooting.
Enables “Dual Shooting” ( pg. 26).
Enables “Progressive Mode Recording” ( pg. 24).
To compensate for unstable images caused by
NOTES:
●Accurate stabilization may not be possible if hand shake is excessive, or under the following conditions:
•When shooting subjects with vertical or horizontal stripes.
•When shooting dark or dim subjects.
•When shooting subjects with excessive backlighting.
•When shooting scenes with movement in various directions.
•When shooting scenes with
●Switch off this mode when recording with the camcorder on a tripod.
●The “
” indicator blinks or goes out if the Stabilizer cannot be used.
:
NOTES:
●The “ 
CAMERA” settings are effective when the Power Switch is set to both “ 
” and “ 
”.
●The “ 
MANUAL” settings are effective only when the Power Switch is set to “ 
”.
CONTINUED ON NEXT PAGE
