JVC GR-DV2000 specifications Audio Dubbing, EN71, To hear the dubbed sound during playback

Display

6e	Audio Dub
	Standby mode

MIC (external

Power Switch microphone input) connector*

Speaker

PHONE (headphone) connector*

Remote sensor

Stereo microphone

EN71

Audio Dubbing

The audio track can be customized only when recorded in the 12-bit mode ( pg. 29).

NOTES:

●Audio Dubbing is not possible on a tape recorded in 16- bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching on the television, make connections (  pg. 54).

1 Play back the tape to locate the point where editing will start, then press PAUSE (6).

2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.

3 Press PLAY (4) , then begin “narrating”. Speak into the microphone.

•To pause dubbing, press PAUSE (6).

4 To end Audio Dubbing, press PAUSE (6), then STOP (5).

To hear the dubbed sound during playback . . .

.... set “12BIT MODE” to “SOUND 2” or “MIX” in the

Menu Screen ( pg. 41, 42).

NOTES:

● Audio dubbing is also possible using an optional

microphone connected to the MIC connector.

● Sound is not heard from the speaker during Audio

Dubbing. To hear sound, connect optional headphones

to the PHONE connector.

● While an optional microphone is connected, the built-in

microphone is disabled.

● When editing onto a tape that was recorded at 12-bit,

the old and new soundtracks are recorded separately.

● If you dub onto a blank space on the tape, the sound

may be disrupted. Make sure you only edit recorded

areas.

● If feedback or howling occurs during TV playback, move

the camcorder’s microphone away from the TV, or turn

down the TV’s volume.

● If you change from 12-bit to 16-bit in mid-recording

DISPLAY

PLAY

A.DUB

and then use the tape for Audio Dubbing, it is not

effective from the point where 16-bit recording began.

● During Audio Dubbing, when the tape moves to scenes

recorded in the LP mode, scenes recorded in 16-bit

PAUSE

STOP

* Located beneath the cover.

audio or a blank portion, Audio Dubbing stops

(  pg. 87).

● To perform Audio Dubbing with a video unit connected

to the camcorder’s AV connector, first set “S/AV INPUT”

to “ON” in the Menu Screen (  pg. 41). You can hear

sound from the video unit using optional headphones.