54 EN | DETAILS | |
| I T E M S | N O T E S |
|
|
|
| ➪ Power | ❍ Perform charging where the temperature is between 10°C and |
| ( pg. 8) | 35°C. 20°C to 25°C is the ideal temperature range for charging. If |
|
| the environment is too cold, charging may be incomplete. |
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of the battery pack.
❍To avoid interference with reception, do not use the AC Adapter near a radio.
❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in
❍The following operation stops charging:
•Set the Power Switch to “ 
”, “ ” or “ 
”.
•Disconnect the AC adapter from the camcorder.
•Unplug the AC adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
➪ BASIC | ❍ When you use the LCD monitor outdoors in direct sunlight, the |
RECORDING | LCD monitor may be difficult to see. If this happens, use the |
( pg. 16, 17) | viewfinder instead. |
| ❍ The cassette holder cannot be opened unless a power supply is |
| attached. |
| ❍ There may be a delay after you open the cassette holder cover until |
| the cassette holder opens. Do not use force. |
| ❍ Once the cassette holder is closed, it recedes automatically. Wait |
| until it recedes completely before closing the cassette holder cover. |
| ❍ When the Recording Start/Stop button is pressed, it may take a few |
| seconds before actual recording starts. “ ” starts rotating when |
| the camcorder actually starts recording. |
| ❍ The time required to calculate and display the remaining tape |
| length, and the accuracy of the calculation, may vary according to |
| the type of tape used. |
| ❍ “TAPE END” appears when the tape reaches its end, and the power |
| goes off automatically if left in this condition for 5 minutes. “TAPE |
| END” also appears when a cassette at its end is loaded. |
