20
EN
INITIAL
SETTINGS
(cont.)
DBS Receiver Control
Suggested Location
Place the DBS (Direct Broadcast Satellite) receiver on top of the VCR. Attach the VCR's Controller to the top of the VCR with the Controller’s transmitter pointed towards the DBS receiver's remote sensor.
Attention:
The Controller can also control a cable box. If both a DBS receiver and a cable box are used, position the controller so its signal reaches the remote control sensors of both the DBS receiver and cable box.
DBS receiver
Your VCR | Controller | |
| (suggested locations) | |
| DBS receiver | |
|
|
|
|
|
|
Controller
|
| Transmitter |
|
|
|
| Connected to | Connected | |
|
| |||
|
| |||
|
| to VIDEO/ | ||
|
| ANTENNA IN | AUDIO IN | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Your VCR
CABLE
BOX
About Your DBS Receiver
This VCR has two separate methods to control your DBS Receiver.
●The VCR's Wireless Remote Control Unit can control your DBS Receiver.
This eliminates the need for a separate DBS Receiver Remote Control Unit.
●The VCR's Controller can also control your DBS Receiver. This allows the VCR to change your DBS receiver's channel number during timer recording.
Each method must be set up separately. To set up the VCR's Remote Control unit, refer to page 53. To set up the Controller go to page 21.
The following procedure is required if you receive satellite channels through a DBS (Direct Broadcast Satellite) Receiver. The Controller allows the VCR to automatically switch the DBS Receiver's channels during timer recording.
The VCR can control the DBS Receiver during timer recording using its Controller.
NOTES:
●The Controller can automatically change the DBS Receiver channels when the VCR has been programmed using On- Screen Timer Programming (☞ pg. 44).
Because satellite programming does not use PlusCode; the Controller can not change the DBS Receiver channels during VCR Plus+ Timer Recording.
●If a cable box is also used it is recommended that you connect the DBS receiver to your VCR's A/V inputs and the cable box to your VCR's antenna input.
Situate And Connect Controller
SITUATE CONTROLLER
1 Place the Controller so that the path between its transmitter and the DBS receiver's remote sensor is unobstructed.
ATTACH CONTROLLER
2 Fasten securely using the supplied adhesive strips.
CONNECT DBS RECEIVER TO VCR
3 The connection method depends on the type of DBS receiver you have.
If your DBS receiver has AUDIO and VIDEO OUT connectors . . .
. . . connect them to the AUDIO and VIDEO IN connectors on your VCR; select the correct external input mode as described in step 4, 5, 9 – 11 on page 48
&49. Set the VCR to channel "AU" to use the DBS receiver.
If your DBS receiver doesn’t have AUDIO and VIDEO OUT connectors . . .
. . . connect the antenna output connector on the DBS receiver to the ANTENNA IN connector on the rear of your VCR.
Set the VCR's tuner to the same channel as the DBS receiver's RF output. (See page 21 also.)
NOTE:
When connecting your DBS receiver refer to its instruction manual.
CONNECT CONTROLLER TO VCR
4 Connect to the CABLE BOX connector on your VCR.
