CABLE/DBS 
MBR SET
POWER
1 2 3
4 | 5 | 6 | NUMBER |
7 8 9
0
CH
E
N
53
DBS Receiver Multi-Brand Remote Control
The VCR's remote control can control functions on the brands of DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS |
RECEIVER |
Turn the power on using the DBS receiver's remote |
1 control. |
ENTER DBS RECEIVER |
BRAND |
While holding down CABLE/DBS on the VCR’s remote |
control, press MBR SET and use the NUMBER keys to |
2 enter the DBS receiver brand number from the chart |
1
3 
Á
¦ 7 8
STOP
4¢
| below and then press STOP. |
| Follow the example shown below. |
|
|
| ● Once you have set the remote control to operate the |
| DBS receiver, you don't have to repeat this step until |
| you replace the remote control's batteries. |
|
|
3 | OPERATE DBS RECEIVER |
First, while holding down CABLE/DBS, press POWER | |
to see if the DBS receiver's power goes off as it should. | |
If it does, try other functions. | |
| ● To operate your DBS Receiver, while holding down |
| CABLE/DBS, press the corresponding button: |
| POWER, CH , NUMBER keys (or ENTER). |
| 5° |
| ● Depending on the DBS receiver you may have to |
| press ENTER after having pressed the NUMBER keys. |
NOTES:
●Depending on the type of DBS receiver, there may be cases where some or all functions cannot be operated using the remote control.
●Though ECHOSTAR has a number of different remote codes, this remote control is applicable only to one of those codes preset at the factory.
●It's not possible to set the remote control for both your DBS receiver and a cable box at the same time. You can only set the remote control to operate one of these units at a time.
DBS BRAND NAME | BRAND CODE |
|
|
RCA (DSS) | 80 |
SONY (DSS) | 81 |
PRIMESTAR | 90 |
ECHOSTAR | 91 |
|
|
(Ex.) To set remote control to RCA (DSS):
CABLE/DBS MBR SET | 8 DAILY | 0 AUX | 7STOP |
|
|
| Release |
Hold | Press in succession |
| |
down |
|
|
|
