![](/images/new-backgrounds/1157250/15725073x1.webp)
|
|
| EN 37 |
OTHER PROBLEMS |
|
| |
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
1. | Whistling or howling is heard from the | ● The camcorder’s microphone is too | Position the camcorder so its microphone |
| TV during camcorder recording. | close to the TV. | is away from the TV. |
|
| ● The TV’s volume is too high. | Turn the TV’s volume down. |
|
|
|
|
2. | The channel cannot be changed. | ● Recording is in progress. | Press 9 to pause the recording, change |
|
|
| channels, then press 4 to resume |
|
|
| recording. |
|
|
|
|
3. | Channel settings that were made | ● After the manual settings were made, | Perform manual setting again. |
| manually seem to have changed or | Auto Channel Set was performed. |
|
| disappeared. |
|
|
|
|
|
|
4. | No channels are stored in the | ● The TV aerial cable was not connected | Turn off the recorder once and connect |
| recorder’s memory. | to the recorder when Auto Set Up was | the TV aerial cable to the recorder |
|
| performed. | properly, then turn on the recorder again. |
|
|
| Then perform Auto Set Up again |
|
|
| ( pg. 8). |
|
|
|
|
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After checking the cassette, operate the unit as usual.