JVC HR-S9500EK Information On J Terminal, Terminal JLIPJoint Level Interface Protocol Connector

Information On J Terminal

J terminal

	1	2	3
			2
NUMBER	4	5	6
	7	8	9
		0	4
	1

OK

MENU

ATTENTION

After you change your recorder's JLIP ID number, control signal transmission may not work properly. If this happens, turn off the recorder's power off once, then turn it back on and try again.

41

J Terminal (JLIP(Joint Level Interface Protocol) Connector)

The J Terminal is used to connect the recorder to a personal computer or similar device to allow computerized control of the recorder during editing and certain other operations.

Examples:

With the optional JLIP VIDEO CAPTURE BOX GV-CB3E:

●Enables Random Assemble Editing of up to 99 segments, using this recorder as the playback unit.

●Allows you to capture still images from the recorder into a personal computer.

For further details consult your nearest JVC dealer.

JLIP ID Number

Your recorder has its own JLIP ID number. This ID number must be unique when your recorder is connected to another device via its J terminal. The ID Number is preset to "1" at the factory. You can change this number to any number between "1" and "99". If it is necessary to change the JLIP ID number perform the following steps.

ACCESS MAIN MENU SCREEN

1 Press MENU.
	ACCESS INITIAL SET SCREEN
	Press %Þ to move the highlight bar (pointer) to
2 "INITIAL SET", then press OK or %.
	ACCESS JLIP ID NO. SET SCREEN
	Press %Þ and move the	INTIAL SET
	highlight bar (pointer) to	CLOCK SET
3 "JLIP ID NO. SET", then
		GUIDE PROG SET
	press OK or%.	JLIP ID NO. SET
		[5°] =
		[MENU] : EXIT
	SET JLIP ID NUMBER
	Press NUMBER keys to	JLIP ID NO. SET
	enter the desired ID
4 number.
			1
		CLOCK SET
		[0-9] =
		[MENU] : EXIT
	RETURN TO NORMAL SCREEN
5 Press OK.