INITIAL SETTINGS

EN 13

Video Channel Set

Video channel (RF output channel) is the channel on which your TV receives picture and sound signals from the unit through the RF cable.

Before performing the following steps:●Make sure there is no cassette inserted in the unit and the power is off.●Slide the TV/VCR/DVD switch on the remote control to the right.

A Access the Video Channel Set mode.

Hold down 8 on the unit until the front display panel shows the following.
B Set the TV system (RF Connection only)

Press PR + or – on the remote control to set the appropriate TV system that matches the system of TV being used (refer to the table below).

1:B/G 2:D/K 3:I 4:H

Major Countries/Areas

TV System

 

 

New Zealand, Kuwait, U.A.E.,

B/G

Indonesia, Singapore, Thailand,

 

Malaysia, Iran, Saudi Arabia, Egypt,

 

Morocco, Lebanon, Iraq

 

 

 

China, Mongolia, Russia

D/K

 

 

Hong Kong

I

 

 

Australia

H

 

 

C Set the video channel.

With AV ConnectionPress ENTER, then press PR – until the front display panel shows “– –”.●Now the video channel is set to off.With RF ConnectionSet your TV to UHF channel 36.

●If the two vertical white bars appear clearly on the TV screen as shown on the right, press ENTER and then go to step D.

●If the two vertical white bars do not appear clearly, press ENTER and then

PR + or – to set the unit to a vacant channel between 28 and 60 which is not occupied by any local station in your area.

(Example) If channel 50 is available in your area

Then set your TV to UHF channel 50 and check if the two vertical white bars appear clearly on the TV screen ; if so, go to step D. If not, re-set the unit to another vacant channel and try again.

NOTES:

●If you set the unit to a channel which is occupied by a local station or has neighbouring channels that are occupied by local stations, the picture reception quality will be affected and some interference noise will appear on the TV screen. Be sure to select a vacant channel which has no broadcast on neighbouring channels.

●If you cannot obtain the two vertical white bars clearly with any channel between 28 and 60, consult your JVC dealer.

D Exit the Video Channel Set mode.

Press ENTER on the remote control.

●If Auto Set Up ( pg. 14) or Tuner Set ( pg. 60) has not previously been performed, the Clock Set screen appears and Auto Set Up takes place automatically.

With AV Connection

To view picture signals from the unit, set your TV to its AV mode.

With RF Connection

The channel you have set in step C above is your video channel.To view picture signals from the unit, set your TV to the video channel.