Filename [XV48EX_EN_10Subsidiary.fm]

 

XV48EX_EN_01.book Page 62 Saturday, October 9, 2004 10:34 PM

Masterpage:Left+

62 EN

 

SUBSIDIARY SETTINGS (cont.)

Setting Station Names by ID Code

B

 

 

Enter the new character.

Set station names by ID codes (“ID”) that are registered in your

Press rt to cycle through the characters (A–Z, 0–9, –,

unit.

 

f, +, I (space) ) and stop when the desired character is

Perform steps A and B of “Manual Channel Set” on page 60

indicated, then press e to enter. Enter the remaining

to access the Confirmation screen before continuing.

characters the same way (maximum of 4). After entering

 

all characters, press ENTER.

 

A Select the item.

Press rt w e until the item you want begins blinking.

The Confirmation screen appears.

If you make a mistake, press w until the incorrect character begins blinking. Then enter the correct character by pressing rt.

B Access the Manual Channel Set screen.

Press ENTER twice.

C Select the new station.

Press e until the station name (ID) begins blinking, then press rt until the new station’s name (ID) you want to store begins blinking. Registered station names ( pg. 63) appear as you press rt.

D Switch the stations.

Press ENTER.

The Confirmation screen appears.

Repeat steps A – D if necessary.

E Close the Confirmation screen.

Press SET UP.

Setting Station Names Manually

You can set station names manually.

Perform steps A and B of “Manual Channel Set” on page 60 to access the Confirmation screen and then perform steps A and B of “Setting Station Names by ID Code” above before continuing.

A Select the character for station name.

Press e until the first letter of the station name begins blinking.

C Close the Confirmation screen.

Press SET UP.

NOTE:

The characters available for the station name (ID) are A–Z, 0–9, –, f, +, I (space) (maximum of 4).

Fine-Tuning a Stored Channel

Perform steps A and B of “Manual Channel Set” on page 60 to access the Confirmation screen before continuing.

A Select the channel to fine-tune.

Press rt w e until the channel you want to tune begins blinking.

B Access the Manual Channel Set screen.

Press ENTER twice. The Manual Channel Set screen appears.

C Perform tuning.

Press e until “+/–” begins blinking, then press rt to obtain the best picture quality. After finishing adjustment, press ENTER.

The Confirmation screen appears.

Repeat steps A – C if necessary.

D Close the Confirmation screen.

Press SET UP.

Page 62

October 9, 2004 10:34 pm

Page 62
Image 62
JVC HR-XV48E manual 62 EN, Setting Station Names Manually, Fine-Tuning a Stored Channel