Masterpage:Right-No-Heading
EN 15
Filename [XVC2829US_06Index.fm]
Page 15 14 December 2004 4:08 pm
Scan Mode Set(DVD deck only)
This unit supports the progressive scan system (eg. 480p*)
as well as the conventional interlaced scan system (eg.
480i*).
If your TV equipped with component video connectors
supports the progressive video input, you can enjoy a
high quality picture by setting the progressive scan mode
to active.
●Refer also to the instruction manuals supplied with your TV.
●If your TV equipped with component video connectors does
not support the progressive video input, do not change the
scan mode to the “PROGRESSIVE.”
* 480p and 480i indicate the nu mber of scanning lines and
scanning format of an image signal.
• 480p indicates 480 scanning lines with progressive format.
• 480i indicates 480 scanning lines with interlaced format.
ATurn on the unit.
Press POWER.
BSelect the DVD deck.
On the unit
Press VCR/DVD repeatedly so that the DVD indicator
lights up on the front display panel.
On the Remote
Press DVD so that the DVD indicator lights up on the
front display panel.
CSwitch the mode.
APress and hold PROGRESSIVE SCAN on the unit for
more than 3 seconds.
The current scan mode blinks on the front display
panel.
BWhile the current scan mode blinks, press we to
select “ProGr” (for the progressive scan mode) or
“IntEr” (for the interlaced scan mode), then press
ENTER.
• If the current scan mode stops blinking before you make
the setting, start from step A again.
NOTE:
When the progressive scan mode is selected, the Progressive
mode indicator ( ) lights up on the front display panel.
●Turn on the TV and select the VCR channel (or AV
mode).
●Slide the TV/VCR/DVD switch on the Remote to the
right.
PROGRESSIVE SCANPOWER
VCR/DVD
POWER
DVD
Slide to the
right.
XVC2829US_06Index.fm Page 15 Tuesday, December 14, 2004 4:08 PM