Filename [XVC2829US_09Editing.fm]
Masterpage:Left0
56 EN
Page 56 8 December 2004 9:56 am
REMOTE
Remote Control Functions

Remote A/B/C/D Code Switching

The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the Remote
Keep pressing VCR down during steps AB.
AChange the remote control code.
Press the number key “1” for A, “2” for B, “3” for C or “4” for D.
BSet the remote control code.
Press ENTER to set the code.
NOTE:
Once the batteries are removed, the remote control code is back
to A.
On the unit
ATurn off the unit.
Press POWER on the unit.
BDisplay the code.
Press 4 PLAY on the unit for over 5 seconds while the unit is turned off. The code currently set appears on the
front display panel.
If the code displayed on the front display panel is different
from the code set on the Remote, go to stepC.
CChange the units code.
Press 8 STOP on the Remote. The code currently set on the Remote will be applied to the unit.
NOTE:
Even if you unplug the end of the mains power cord from the
mains, the code currently set remains.
Before performing the following steps:
Slide the TV/VCR/DVD switch on the Remote to the right.
VCR
7 STOP
ENTER
Number keys
Slide to the
right.
POWER
3 PLAY
XVC2829US_01.book Page 56 Wednesday, December 8, 2004 10:48 AM