Assigning names to the sources
You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and external component (Line
After assigning a name, it will appears on the display when you select the source.
Sources | Maximum number of | |
characters | ||
| ||
|
| |
Station frequencies | Up to 9 characters (up to | |
| 30 station frequencies | |
| including both FM and | |
| AM) | |
|
| |
CDs*1 | Up to 32 characters (up to | |
| 40 discs) | |
|
| |
External component | Up to 12 characters | |
(Line Input)*2 |
|
*1 You cannot assign a name to a CD Text or an MP3/WMA disc.
*2 Only for
1Select a source you want to assign a name to.
(For | (For |
(For
When you select a source, the power automatically comes on.
2While pressing DISP (display), press and hold SEL (select) for more than 2 seconds.
Ex.: When you select CD as the source
3 Select the character set you want | ENGLISH | ||
while the first character position is | |||
| |||
flashing. |
|
| |
Each time you press the button, |
| ||
the character set changes as |
| ||
follows: |
|
| |
(A – Z: capital) | (a – z: small) |
| |
(0 – 9: numbers, and |
| ||
symbols) |
| ||
4 Select a character. |
|
| |
• About the available |
| ||
characters, see page |
| ||
40. |
|
|
5Move the cursor to the next
(or previous) character position.
6Repeat steps 3 to 5 until you finish entering the name.
7Finish the procedure while the last selected character is flashing.
To erase the input characters
To erase all the characters at a time, press and hold DISP (display) for more than 1 second as described in the procedure above.
Notes:
•When you try to assign a name to a 41st disc or to the 31st station frequency, “NAME FULL” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.
•Only for
When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can |
|
also be shown on the display if you insert the CDs |
|
in this unit. | 31 |