JVC KD-LH1101 manual Troubleshooting, Symptoms Causes Remedies, LOW TEMP. indicator

TROUBLESHOOTING

ENGLISH

54

What appears to be trouble is not always serious. Check the following points before calling a service center.

		Symptoms	Causes			Remedies
	•	Sound cannot be heard	The volume level is set to the	Adjust it to the optimum level.
		from the speakers.	minimum level.
			Connections are incorrect.	Check the cords and
				connections.
	•	This unit does not work	The built-in microcomputer may	Press the reset button on the
		at all.	have functioned incorrectly due	panel holder after detaching the
General			to noise, etc.	control panel. (The clock setting
				and preset stations stored in
				memory are erased.)
				(See page 2.)
	•	“Panel Connect Error”	The control panel is not attach	Remove the control panel, wipe
		appears on the display.	correctly and firmly.	the connectors, then attach it
				again. (See page 39.)
	•	“Movie” category	Temperature in the car	Wait until the operating
		settings in the PSM do	compartment is very low—	temperature resumes—until
		not take effect.	(LOW TEMP.) indicator appears.			(LOW TEMP.) indicator
				goes		off.
	•	SSM (Strong-station	Signals are too weak.	Store stations manually.
FM/AM		Sequential Memory)
		automatic preset does
		not work.
	•	Static noise while	The aerial is not connected	Connect the aerial firmly.
		listening to the radio.	firmly.
	•	CD cannot be played	CD is inserted upside down.	Insert the CD correctly.
		back.
	•	CD-R/CD-RW cannot be	CD-R/CD-RW is not finalized.	•	Insert a finalized CD-R/
		played back.			CD-RW.
	•	Tracks on the CD-R/		•	Finalize the CD-R/CD-RW
		CD-RW cannot be			with the component which
		skipped.			you used for recording.
	•	CD cannot be ejected.	CD is locked.	Unlock the CD. (See page 25.)
PlaybackCD	•	CD cannot be recognised	The CD player may function	While holding CD/CD-CH, press
	•	CD sound is sometimes	You are driving on rough roads.	Stop playback while driving on
		(“No Disc,” “Loading	incorrectly.	SEL (select) for more than
		Error,” or “Eject Error”		2 seconds to eject the CD.
		flashes on the display.)
		interrupted.		rough roads.
			CD is scratched.	Change the CD.
			Connections are incorrect.	Check the cords and
				connections.
	•	“No Disc” flashes on the	No CD in the loading slot.	Insert a CD into the loading slot.
		display.
			CD is inserted incorrectly.	Insert the CD correctly.