JVC KD-LH1101 Assigning names to the sources, English, To erase the entered characters, letters

• About the available characters, see page 53.

Move the cursor to the next

(or previous) character position.

Repeat steps 3 to 5 until you finish entering the name.

ENGLISH

Assigning names to the sources

You can assign names to CDs (both in this unit and in the CD changer) and the external component.

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters

*You cannot assign a name to a CD Text (and MP3 discs in the CD changer).

1 Select a source you want to assign a name to.

CD CD-CH

(or LINE-IN)

When you select a source, the power

automatically comes on.

2 While pressing D (DISP), press and

hold SEL (select) for more than 2 seconds.

The next-step-operation buttons start flashing.

Ex.: When you select CD as the source

3 Select the character set you want while the first character position is flashing.

Each time you press the button, the character set changes as follows:

		(A – Z: capital)		(a – z: small)
		(Accented letters:
		lower case)
				(0 – 9: numbers,
	(Accented		letters:
		upper case)		and symbols)
4 Select a character.

5

6

7 Finish the procedure while the last selected character is flashing.

To erase the entered characters

Insert spaces using the same procedure

described above.

Notes:

•When you try to assign a name to the 41st disc, you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

38