Menu Configuration-SET-UP MENU, Color Temp, Information

Menu Configuration—SET-UP MENU

Item	To do	Setting value
COLOR TEMP.	Display the color temperature.
R DRIVE, G DRIVE,	Adjust the drive level of each color (red, green, and blue).	MIN += 000 += MAX

Item	To do	Setting value
STATUS DISPLAY Set if you want the information of the current input to		AUTO, OFF
	be displayed on the screen (see “Displaying the current
	status” on page 11).

B DRIVE		(in 256 grades)
R CUT OFF, G CUT	Adjust the cut-off point of each color (red, green, and	MIN += 000 += MAX
OFF, B CUT OFF	blue).	(in 256 grades)
reset	Restore the default setting for all the items in “COLOR TEMP.”

•Adjust the color temperature after selecting color temperature (HIGH, MID, LOW, or USER) on the main menu (see “PICTURE SETTING” on page 13).

SUB HOUR METER

reset

MODEL

VERSION

HOUR METER

Display the hours of current use (unit: hour). You can reset only this item by pressing 3.

Restore the default setting for “STATUS DISPLAY” and “SUB HOUR METER.”

Display the model name and version of the monitor. This item is used for maintenance of the monitor.

Display the total hours of use (unit: hour). This item is used for maintenance of the monitor. This item cannot be reset.

Item	To do	Setting value
NO SYNC ACTION	Select the screen color or the screen status applied when	OFF, GRAY BACK (gray
	no signal is coming in.	screen), POWER SAVE
		(power save), RED,
		GREEN, BLUE
DELAY TIME	Set the time to change the screen color/screen status	30sec., 5min., 15min.
	set in “NO SYNC ACTION” above after signal-incoming
	stopped.
reset	Restore the default setting for all the items in “SYNC FUNCTION.”

• While the Dual Display is activated, the Sync Function works only for the main window.

Item	To do	Setting value
ID	Assign the ID to the monitor.	01 += 25
REMOTE IN SEL.	Select the input terminal used for external control.	D-sub9 (RS-232C input),
		RJ-45 (RS-485 input/
		output), LAN (Ethernet
		terminal)
CNT. RJ45 OUT	Select the external control method for RS-485 OUT	RS485, IR OUT
	terminal.
CNT. RJ45 IN	Select the external control method for RS-485 IN terminal.	RS485, MAKE, TRIG.,
		SET
PORT F1 – PORT	Assign the control function to the RS-485 IN terminal’s	– – – (no function),
F5	pins (1 to 5) when selecting “SET” in “CNT. RJ45 IN”	VIDEO, RGB, DVI,
	above.	POWER, ASPECT,
		MUTING, PIP, PBP
reset	Restore the default setting for all the items in “REMOTE SYSTEM.”

• For details about external control, see pages 20 to 25.

Item	To do	Setting value
SECURITY LOCK	Activate/deactivate the Security Lock.	ON, OFF
PASS ID SETTING	Set the password for the Security Lock.	4 numbers

• For details about the Security Lock, see page 17.