Accessories/Controls and Features (continued)REAR

A B

 

C

 

D

E

F

 

 

 

 

 

 

 

 

 

ANALOG INPUTS

ANALOG OUTPUTS

 

 

 

AC INPUT

S-VIDEO

VIDEO

Cr/Pr/R

Y/Gs

Cb/Pb/B

C-SYNC

PASS-THRU

MONITOR

RED/Pr GREEN/Y BLUE/Pb

H SYNC

V SYNC

 

DVI INPUT

 

 

IR LED

SCREEN

 

DVI OUTPUT

RS-232 OPTION

RS-232 CONTROL

 

G

 

 

H I

 

J

K

L

M

N

A[S-VIDEO]Input Terminal (4-pin mini DIN)

For input of S-video (Y/C) output signals of sources such as video decks.

B[VIDEO] Input Terminal (BNC)

For input of composite video output signals of sources such as video decks.

C[Cr/Pr/R, Y/Gs, Cb/Pb/B, C-SYNC]Input Terminal (Component/RGB input terminal BNC)

For input of 480i/480p, 576i/576p or 720p/1080i, 50 Hz/60 Hz signals.

●For output of the above signals upon converting to the scan rate specified in the Setup menu.

D[PASS-THRU]Input Terminal (Pass-through input terminal, D-sub 15 pin)

High scan rates for sources such as video signals of HDTV or computers are passed through to the analog outputs terminal. This processor is unable to project signal input from this terminal using the projector.

●Input signals sent to this terminal are not converted or transcoded (from YPrPb to RGBHV).

●Output to the [MONITOR] terminal is possible.

●Usually, this terminal is not used.

E[MONITOR] Output Terminal (Monitor output terminal, D-sub 15 pin)

For use with computer monitors or to a second display device.

●Usually, this terminal is not used.

●Set ASET: ACTIVE OUTPUTB of the Setup menu to AANALOG RGB+DVIB or AANALOG RGBB.

(A Page 22)

●When HDCP signal input is sent to the DVI input terminal, video signals will not be output from the analog terminal. In this case, an AENCRYPTED SOURCE ANALOG OUT DISABLEB message will appear on the LCD.

●This cannot be used simultaneously with the DVI output terminal.

●Use a D-sub cable within 3 m to prevent attenuated and ringing signals. Also, make use of a 75KD15-BNC conversion cable.

F[RED/Pr, GREEN/Y, BLUE/Pb, H/V SYNC] Output Terminal (BNC)

For connection to a display device with an input terminal for RGBHV or YPrPb signals.

●Usually, this terminal is not used.

●If computer signals are to be used, separate H & V sync cables must be connected to the display.

●Set ASET: ACTIVE OUTPUTB of the Setup menu to a value other than ADVIB. (A Page 22)

10