Adjustments and Settings Using Menus (continued)
Setup Menu Configuration

................................................................................................

SET: NTSC SCANRATE

(Output scan rate setting for NTSC signals)

Sets the output scan rate of NTSC signals. Set to A1920  1080B.

Setting Values:

1280  720, 1024  768, 1280  768, 1366  768, 1440  960, 1280  1024, DILA, DILA3,

1920  1080, 1400  788, 1920  540, 800  600 Default Value: 1280  720

●Press the [STORE] button twice to confirm the setting and store it as a profile. Please refer to 19 and 26 for details on profile setting.

................................................................................................

SET: PAL SCANRATE

(Output scan rate setting for PAL signals)

Sets the output scan rate of PAL signals. Set to A1920  1080/50HzB.

Setting Values:

1280  720/50Hz, 1024  768/75Hz, 1024  768/ 100Hz, 1920  1080/50Hz, 720  576/50Hz, 720  576/100Hz

Default Value: 1280  720/50Hz

●Press the [STORE] button twice to confirm the setting and store it as a profile. Please refer to 19 and 26 for details on profile setting.

................................................................................................

SET: SCREEN SHAPE

(Screen shape setting for projector)

Sets the screen shape of the projector that is connected to this unit.

Setting Values: WIDESCREEN, WIDE 4:3, 4:3

Default Value: WIDESCREEN

oWIDESCREEN

Choose this when projecting 16:9 or 2.35:1 images from the projector onto a wide screen.

oWIDE 4:3

Choose this when projecting a 4:3 image from the projector onto a wide screen. (Not available on units scanning at rates below 720p.)

o4:3

Select this when using a 4:3 screen.

................................................................................................

SET: ANALOG BLACK LVL

(Level setting for black analog signals)

Sets the black signal level of the YPrPb component video signal.

Setting Values: 0 IRE, 7.5 IRE

Default Value: 7.5 IRE

................................................................................................

................................................................................................

SET: ACTIVE OUTPUT

(Output signal setting)

Sets whether to output analog signals (BNC, D-sub) or digital signals (DVI) to the output terminal of this unit.

Setting Values:

ANALOG RGB+DVI, ANALOG YPrPb, DVI, ANALOG

RGB

Default Value: ANALOG RGB+DVI

●Select AANALOG RGB+DVIB to output both digital and analog signals. However, output of YPrPb signals is not possible.

●Each of the output format can be stored as a separate profile. (A Pages 19, 26)

●There will be no output to the analog terminal when HDCP signals are input to the DVI input terminal of this unit. In this case, an AENCRYPTED SOURCE ANALOG OUT DISABLEB message will appear on the LCD.

SET: COMP SYNC ON H

(Composite sync signal setting)

Sets the horizontal/vertical sync signals when connected via the analog RGB output (4-wire connection). When this is set to AONB, composite sync signals will be output from the [H SYNC] terminal.

Setting Values: OFF, ON

Default Value: OFF

●This processor is used via a DVI connection to the projector, and therefore this setting is not required.

●Setting is enabled when you select AANALOG RGB+DVIB or AANALOG RGBB in the ASET: ACTIVE OUTPUTB setting.

22