ENumber Buttons

Use these to adjust the OSD menu items, such as brightness and contrast (items that are adjusted using numeric values). (A Page 27)

FPicture Adjustment Buttons

Use these to adjust Brightness, Contrast, Color, Tint and Detail. Press the corresponding picture adjustment button, followed by the number buttons to enter a setting value.

●These items can also be adjusted in the OSD menu. (A Page 27)

[BRIGHTNESS] Button

Adjusts the brightness of the picture image. (Factory default value: 50)

[CONTRAST] Button

Adjusts the contrast of the picture image. (Factory default value: 50)

[COLOR] Button

Adjusts the color density of the picture image. (Factory default value: 50)

[TINT] Button

Adjusts the hue of the picture image. (Factory default value: 50)

●Adjust this when the colors in the video image do not seem balanced under the current tint settings.

●This item cannot be adjusted for component (YPrPb) signals.

[DETAIL] Button

Adjusts the image quality. (Factory default value: 4)

●Select your preferred setting values according to the image to be viewed.

NOTE:

The buttons below will not function if ASET: 1080i TO 1080pB is set to AHIGH BANDWIDTH MODEB. In this case, a AHIGH BANDWIDTH MODE KEY NOT VALIDB message will appear on the LCD.

●[DETAIL] Button

●[ANAMORPHIC] Button

●[4:3] Button

●[LETTERBOX] Button

GPicture Size Adjustment Buttons

Use these to set the aspect ratio of video signal output from this unit.

●Set the screen shape (aspect ratio) in the Setup menu. (A Page 22)

[ANAMORPHIC] Button

Select this during output of 16:9 video signals.

●When input images are cinema images (aspect ratio of 2.35:1), these will be output as 16:9 video signals with a black band at the upper and lower ends of the image.

[4:3] Button

Select this during output of 4:3 video signals.

CAUTION:

Do not leave those other than 16:9 images (4:3, etc.) with a 16:9 screen on for long periods of time. This can cause permanent image burn-in. Image burn-in is not covered by warranty.

[LETTERBOX] Button

When using a 4:3 source on a 16:9 screen, black bars will appear on the left and right of the image. Select this to clear the black bars and for the image to fill the screen. The image will fill the screen but part of the image at the top and bottom will not be displayed.

H[OFF] Button

Press this to switch to the standby mode when the power of this unit is turned On. (A Page 19)

IPower On Button

Press to turn the unit On when it is in the standby mode. (A Page 18)

J[STORE] Button

Press this button to select an output scan rate (ASET: NTSC SCANRATEB or ASET: PAL SCANRATEB of Setup menu), store the profile data upon modifying, or invoke a profile number.

(A Page 26).

ENGLISH

13