Basic Operation Procedures
Simply perform the following steps to start viewing video images. If other settings are required, please do so by referring to AAdjustments and Settings Using MenusB.
OFFa - B
VIDEO
b | |
|
DVDPASS/TX
MENU
c
PROFILESTORE
1 2 3
4 5 6
7 8 9
0
BRIGHTNESS CONTRAST
COLOR TINT DETAIL
ANAMORPHIC 4:3 | LETTERBOX |
Indicator
a - B
Preparation:
●Turn on the power of the input device and projector.
aTurning on the powerAInsert the power plug to the power outlet●This unit starts to initialize upon inserting the power plug to the outlet.
●After initialization is complete, the unit switches to the standby mode (indicator lights up in red).
BPress the Power On button on the remote control (or the Power/Standby button on the processor)
●The indicator on the processor lights up in green.
bPress an input selection button on the remote control to select the input source
●It may take a while to display the screen upon input of a HDCP signal.
●A ARATE NOT SUPPORTEDB message will appear on the LCD if a signal that is not compatible with this unit has been input.
cSetting the output resolutionAPress the [MENU] button on the remote control for 7 seconds to enter the Setup menu
BPress the [J/K] buttons to select ASET: NTSCSCANRATEB or ASET: PAL SCANRATEB●Select ASET: NTSC SCANRATEB when the input signal is an NTSC signal.
●Select ASET: PAL SCANRATEB when the input signal is a PAL signal.
CPress the [J/K] buttons to select A1920 1080B or A1920 1080/50HzB●Select A1920 1080B when the input signal is an NTSC signal.
●Select A1920 1080/50HzB when the input signal is a PAL signal.
DPress the [STORE] button twice to save the output resolution●An image will appear on the screen.
EPress the [MENU] button twice to endNOTE:When using a 4:3 screen, perform the following setting as well after setting the output resolution.
1.Set ASET: SCREEN SHAPEB of the Setup menu to A4:3B (A Page 22)
2.Press the [4:3] button on the remote control
●The output video signals of this unit are now set to an aspect ratio of 4:3.
18