Adjustments and Settings Using Menus (continued)

................................................................................................

SET: DVI INPUT H SYNC

(Horizontal sync signal setting during DVI input)

Sets when horizontal sync signals do not match.

Setting Values: NORMAL, WIDE

Default Value: NORMAL

●This setting is enabled when DVI input is selected.

................................................................................................

SET: OSD

(On-screen display setting)

Sets whether to display the OSD menu on the screen.

Setting Values: ON, OFF

Default Value: ON

................................................................................................

SET: OSD TIMER

(OSD timer setting)

Sets the on-screen display time.

Setting Values: 0-255

Default Value: 30

................................................................................................

SET: LCD TIMER

(LCD timer setting)

Sets the backlight of the LCD.

Setting Values: ALWAYS ON, 06-255

Default Value: 30

................................................................................................

SET: RS232 ECHO

(RS-232Cecho setting)

Set to AONB when returning a RS-232Ccommand from this unit to an external control device. Please refer to 30 for details on RS-232Ccodes.

Setting Values: ON, OFF

Default Value: ON

................................................................................................

SET: BAUD RATE

(RS-232Cbaud rate setting)

Sets the baud rate of RS-232C.

Setting Values: 9600, 19200, 57600

Default Value: 19200

................................................................................................

SET: SCREEN TRIGGER

(Screen trigger setting)

Controls the screen trigger-compatible elevating screen. Set this to AONB to output DC +12 V from the [SCREEN] terminal when the power of this unit is on. No output when this is set to AOFFB.

Setting Values: ON, OFF

Default Value: ON

................................................................................................

SET: 1080i TO 1080p

(Output scan rate setting for 1080i signals)

Sets the mode of converting 1080i signals. This is enabled only when the output scan rate is set to 1080i. Select AHIGH BANDWIDTH MODEB to convert to a maximum bandwidth without adjusting the picture image (level, aspect ratio, etc.). Select AENHANCED MODEB for a full image adjustment and minimum reduction in bandwidth.

Setting Values:

HIGH BANDWIDTH MODE, ENHANCED MODE

Default Value: HIGH BANDWIDTH MODE

●This setting is enabled when the image output signal

(ASET: NTSC SCANRATEB or ASET: PAL SCANRATEB) is set to A1920  1080B or A1920  1080/50HzB.

................................................................................................

SET: NTSC PROFILE

(Profile setting for NTSC signals)

Stores all setting values of the NTSC signal to the selected profile number.

Setting Values: STORE PROFILE 1-8

Default Value: STORE PROFILE 1

................................................................................................

SET: PAL PROFILE

(Profile setting for PAL signals)

Stores all setting values of the PAL signal to the selected profile number.

Setting Values: STORE PROFILE 1-8

Default Value: STORE PROFILE 1

................................................................................................

SET: RESTORE FACTORY

(Default setting)

Restores to the factory settings.

●Performing this setting clears all profiles and setting values.

●Use this command when this unit is unable to function properly at all, or after all system checks have been completed.

●Before using this command, unplug the power plug of this unit. Alternatively, press the reset switch at the front of this unit (inside the hole) lightly using a non-pointed, stiff thin rod. This will reset the software without clearing the settings.

24