PROBLEM
“OVERLOAD” starts flashing on the display.
POSSIBLE CAUSE | SOLUTION | |
Speakers are overloaded because of | 1.Press STANDBY/ON | on the front panel to |
high volume. | turn off the receiver. |
|
| 2.Stop the playback source. | |
| 3.Turn on the receiver again and adjust the volume. | |
|
|
|
Speakers are overloaded because of | Press STANDBY/ON | on the front panel to turn |
short circuit of speaker terminals. | off the receiver, then check the speaker wiring. | |
| If “OVERLOAD” does not disappear, unplug the AC | |
| power cord, then plug it back again. |
If speaker wiring is not
The STANDBY lamp lights up after turning on the power, and soon the receiver turns off again (into standby mode).
The receiver is overloaded because of high voltage.
Press STANDBY/ON on the front panel to turn off the receiver. After unplugging the AC power cord, consult your dealer.
Remote control does not work.
There is an obstruction between the | Remove the obstruction. |
remote sensor on the receiver and the |
|
remote control. |
|
|
|
Remote control does not work intendedly.
Batteries are weak.
An incorrect remote control operation mode is selected.
Replace batteries. (See page 15.)
Select the correct remote control operation mode. (See pages 51 to 53.)
58