JVC RX-8022PSL manual Connecting the Speakers, AM Antenna Connections, Typical speaker layout

AM Antenna Connections

ANTENNA	Turn the loop until you have
FM 75	the best reception.
COAXIAL

AM		AM Loop Antenna
LOOP		(supplied)
	AM
	EXT	Snap the tabs on the loop into the
		slots of the base to assemble the
		AM loop.
1	2	3

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of surround speakers to enjoy the surround effect.

•One surround back speaker or one pair of surround back speakers to enjoy 6.1-channel sound reproduction.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible Surround and DSP effect. For details, see page 22.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Outdoor single vinyl-covered wire (not supplied)

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.)

Typical speaker layout
Center speaker
	Subwoofer
Left front speaker(s)	Right front speaker(s)
Left surround speaker	Right surround speaker
Surround back speaker(s)
	6