JVC LVT0953-001B Assembly, Assembling the satellite speakers, Attaching the leg and the stand

Assembly

Assembling the satellite speakers

Each speaker (except the center speaker) has been divided into three parts for shipment. Before using this speaker system, assemble it first by following the procedure below.

Speaker	Leg	Stand
section

•Prepare a Phillips screw driver.

Before assembling—

•Take care not to drop the stand while assembling; otherwise, it may cause damage to the floor or injury.

•Ensure enough space for assembly and installation.

•Place a large, thick cloth on the floor where you assemble the speaker, so you can protect the floor and the speaker itself.

•Use the speaker only after assembly is fully and correctly done.

Attaching the leg and the stand

1 Remove the terminal cover from the leg.

First remove the screw on the terminal cover, then detach the cover by pulling it upward.

•You will need to use the removed screw in step 5 on page 5.

Terminal cover

Screw

claws

grooves

Leg

2 Join the leg to the stand.

•Rotate either the leg or stand so that the mark on the

leg and the mark on the stand are facing the same direction.

•Make sure to match the screw holes on the leg with those on the stand so that they are aligned correctly.

mark

Leg

Stand

mark

3 Fix the leg to the stand with three of the supplied screws (long: M4 x 25 mm).

Leg

Stand

Screw

•Do not tighten each screw completely as you put them in place.

First put all screws in, then tighten them evenly and firmly.

It is recommended to place a cushion under the leg.

•You can tighten the screws easily by placing the leg horizontally.

Cushion

– 4 –