JVC LVT1002-001B manual Troubleshooting, RX-ES1SL, Problem, Possible Cause, Solution, General

Troubleshooting

Use this chart to help you solve daily operational problems. If there are any problems you cannot solve, contact your JVC’s service center.

RX-ES1SL

PROBLEM	POSSIBLE CAUSE	SOLUTION
The power does not come on.	The power cord is not plugged in.	Plug the power cord into an AC outlet.

No sound from speakers.	Speaker signal cables are not connected.
	An incorrect source is selected.
	Muting is activated.
	An incorrect input mode (analogue or
	digital) is selected.
	Connections are incorrect.
	TV Direct is activated.

Check speaker wiring and reconnect if necessary.

Select the correct source.

Press MUTING to cancel the mute.

Select the correct input mode (analogue or digital).

Check connections.

Deactivate TV Direct (see pages 13 and 20).

Buttons cannot be used.	TV Direct is activated.	Deactivate TV Direct (see pages 13 and 20).
Sound from one speaker only.	The balance is set to one extreme.	Adjust the balance properly (see page 21).
The STANDBY lamp lights up after	Speakers are overloaded because of high	1. Press STANDBY/ON	on the front panel to turn
turning on the power, but soon the unit	volume.	off the unit.
turns off (into standby mode).		2. Stop the playback source.
		3. Turn on the unit again, and adjust the volume.
	Speakers are overloaded because of a	Check the speaker wiring.
	short circuit at the speaker terminals.	If speaker wiring is not short-circuited, contact your
		dealer.
	The unit is overloaded because of a high	Consult your dealer after unplugging the power cord.
	voltage.
“OVER HEAT” flashes on the display,	The unit is overheated because of high	Turn on the unit again. If the unit turns off soon,
then the unit is turned off.	volume or long time usage.	consult your dealer after unplugging the power cord.
Remote control does not operate as	The remote control is not ready for your	Press a source selecting button or TONE first, then
you intend.	intended operation.	press the buttons you want to use. (See pages 21,
		62, 63 and 64.)
Remote control does not work.	There is an obstruction hiding the remote	Remove the obstruction.
	sensor on the unit.
	Batteries are weak.	Replace batteries.
	The mode selector is set to the incorrect	Set the mode selector to the proper position.
	position.
Bass sound is reinforced too much	Appropriate bass level is not selected.	Adjust audio position level (see page 22).
when listening in stereo.

General

65